Landrover Discovery 2.7tdv6 egr off needed

[budG60]

Hi, half a year ago I have removed the dpf of a Landrover 2.7tdv6 with SID201 ecu which works perfect (see attached files), but now the egr is giving problems. Can someone remove the egr in the attached dpf off file for me?

[mafia666]

Sorry to get into your topi, but how did you read it? What tool? Through obd ?

[weber]

pass p.m........

[Saulius Saulius]

Hi, half a year ago I have removed the dpf of a Landrover 2.7tdv6 with SID201 ecu which works perfect (see attached files), but now the egr is giving problems. Can someone remove the egr in the attached dpf off file for me?

Hi could you share pass of file with egr off? Thank you.

[budG60]

Sorry to get into your topi, but how did you read it? What tool? Through obd ?

I have used powergate

[Nio]

Hi, i don't think swiftec make this solution good. BR.

[budG60]

Yes you are right. Swiftec does not work! Anybody else can help?


Hi, i don't think swiftec make this solution good. BR.

[Babos]

i think there be 2 egrs?
what problem you have elektric or mehanic?

[budG60]

The problem is related to the egr electronics

[will4u69]

Don't think you can blank remove egr valves on 2007》 model onwards without problems.

Sent from my GT-I9300 using Tapatalk 2

[budG60]

With the swiftec file + closing the egr openings the car seems to run fine, but the fault codes and engine check light is on.

[djbiugi]

Hi...i have same electrical problem..anyone can delete to me P0490 ? after egr off, Range Rover run correctly,but rest P0490

ori file attached

[djbiugi]

Please,can anyone delete P0490 dtc error?
thanks

[johncooper85]

its possible the pass?

[boomeer]

Please,can anyone delete P0490 dtc error?
thanks
hi try dtc off
pass pm

[Jay09]

hello!
can anyone do egr off please (or DTC off P0490 )
LAND ROVER Discovery, 2009
engine 276DT (2.7 L TDI), 190.4PS
HW: 8H2Q-12B6 Siemens SID201
SW: 8H22-12K532-MD

[Jay09]

solved, thanks.

[green1]

2008 2.7 TDV6, Came in with full limp & P0490 EGR's not blanked. Still limp mode with swiftec so blanked both EGR's & now P0489 & not limp but not full power either. so DTC off with clone MTX & no more MIL or 0489 but still not full power & "Engine System Fault" message in dash.



Does anyone have a good manual ( not swiftec etc ) solution ? i suspect EGR stepper motor is causing issue but aren't sure. With left bank EGR electrical plug disconnected , it drives the same - OK ish , but has more related DTC's & MIL.

Using VCDS generic mode for diag as china delphi wont work on it.

[green1]

Will now try plugging in a new LEFT SIDE EGR , temporarily,