PDA

View Full Version : DPF OFF on Skoda Octavia 2.0 TDI 170 HP RS



doberman95
3rd February, 2014, 04:08 PM
dear all,


I need your help for dpf off on my Skoda Octavia 2.0 TDI 170 HP RS, the Ecu is a siemens PPD,

you can fin in attachment the ori file, I hoppe you're can help me, the vehicle is on protection ecu and I cannot drive with this conditions.

thanks in advance for your precius help
best regards 243616

sinan33
3rd February, 2014, 04:32 PM
dear all,


I need your help for dpf off on my Skoda Octavia 2.0 TDI 170 HP RS, the Ecu is a siemens PPD,

you can fin in attachment the ori file, I hoppe you're can help me, the vehicle is on protection ecu and I cannot drive with this conditions.

thanks in advance for your precius help
best regards 243616
Hi!
This is your file.

doberman95
3rd February, 2014, 05:16 PM
dear Sinan33,

than you verry much for your fast reply, I'll test and report quicly,

best regards

sinan33
3rd February, 2014, 05:19 PM
dear Sinan33,

than you verry much for your fast reply, I'll test and report quicly,

best regards
Your wellcome, please checksum it before flashing.
I am waiting for your feedback.

doberman95
3rd February, 2014, 05:23 PM
Who do you mean by Checksum ? ( I control if it is the same ? )

thanks and sorry I'm not a professionnal on this ...

sinan33
3rd February, 2014, 05:24 PM
Check your flashing tool manuel, it shows if it can automatically checksum it or not.

doberman95
3rd February, 2014, 05:27 PM
So, I has used MPPS V12, normally I think so,

I'll check, thanks a lot

regards

doberman95
3rd February, 2014, 05:52 PM
Dear friend,

I confirm the MPPS V12 cheched the checksum automaticly, So the Mil on of the DPF is always present on the dashboard, I checked with the Vag Com and I don't have DTC's stored in the ECM, The vehicle worked verry bad to the ECU is on security mode,

can you please have a look again
thanks
regards

sinan33
3rd February, 2014, 05:57 PM
I am looking now.
Did you get the dpf out manually?

doberman95
3rd February, 2014, 06:04 PM
I'll put it out after reprogramming,

thanks

sinan33
3rd February, 2014, 06:07 PM
Dear friend,

I confirm the MPPS V12 cheched the checksum automaticly, So the Mil on of the DPF is always present on the dashboard, I checked with the Vag Com and I don't have DTC's stored in the ECM, The vehicle worked verry bad to the ECU is on security mode,

can you please have a look again
thanks
regards
Try these two files.

doberman95
3rd February, 2014, 06:35 PM
dier friend,

I tried the 2 files, for the both the engine worked better but the Mil dpf is always on.

regards

digi men
3rd February, 2014, 06:41 PM
do you have made befor flashing the dpf off files

1. write good dpf off file

2. reset DPF with VAS

3. if will have problem and still will have light on dash only run

dpf regenration 10-15 min on road but with dpf off file.

sinan33
3rd February, 2014, 06:41 PM
Maybe you should disconnect the sensors.

doberman95
3rd February, 2014, 06:54 PM
who do you reset DPF with the vas ? do you know the process ?

thanks

Sinan33, I'll try your thougth thanks !

nexusjose
3rd February, 2014, 07:03 PM
I have the same car whith EGR off, which fault have in Vagcom ?

doberman95
3rd February, 2014, 07:06 PM
hi,

I don't have dtc's stored, I think these dtc's is stored in the ori file and better he need to removed too with the dpf I think but I'm not sure !

digi men
3rd February, 2014, 07:07 PM
You can make it wit vag com if you have it ,look on ross tech site for manual !

Passat 2.0 TDI Siemens PPD 1.2.

1. with original software i had to make forced filter regeneration
2. cancel all errors
3. read file
4. send it to a Professional Tuning Company which modified the file
(with Volta No Chance)
5. Rewrite the file, and eliminated the filter

with the filter on the car the light was on, when i've eliminated the filter the light went off by itself.

nexusjose
3rd February, 2014, 07:10 PM
ok , have my ori whithout dtc, use my file to see where you have faults, use a hex comparison

sinan33
3rd February, 2014, 07:16 PM
Egr off and dpf off is different modifications, so this file is useless for him :)

doberman95
3rd February, 2014, 07:17 PM
thank you friend

nexusjose
3rd February, 2014, 08:20 PM
This file is original, is not modify . if you compare your file, you see with part have different addition to your Dpf off, this differents are DTCs ??

doberman95
4th February, 2014, 11:23 PM
dear all,

I find a good file with DPF off but the pdf mil on is alwais on in the dashbord, do you know why ?

thanks

sinan33
5th February, 2014, 02:08 PM
The file which i have sent you was a good file too.The dtc error doesn't related directly with the file.
You should try the solution of digimen, i made researches about the issue and i saw that the common issue with these ecus is dtc error and the solution is the solution which digimen wrote.