Peugeot 307 2003 dash sagen

[hackbest]

Hello fellow have to change dash and is a sagem and need pinout for bsi bsi and dash.


is possible to make this car with xprog thanks and regards.

[hackbest]

I need pinout bsi have one but do not read the xprog

[baze007]

If it is an original that you can do.......but clone i dont know for hc912 always use UPA

[hackbest]

ok ya got read but now the car will not start to do immo off and put quisera 120000

I have if you can lend a hand thanks and greetings

[hackbest]

resolved as the only boots I need if I can vary bsi 120000 thanks

[baze007]

immo off i not posible via bsi dump.......

[baze007]

..............................

[hackbest]

recorded disconnect battery and connect battery connect bsi and should grab new value

[hackbest]

Hello again recorded file gets the new value but to remove contact picks up again
old value I do wrong

[hackbest]

anyone can help me with this car I have crazy trick that I do to be impressed with the dash

[baze007]

disconect battery ....
put dump in your dashboard
put dump in your bsi
both dumps must have some km (120000km)
conect bsi
conect dash and
conect battery

[hackbest]

this board can not be recorded with xprog and put this trash

Instruction: read the 68HC912DG128 chip from the BSI (Valeo), and
edit the mileage as shown here. Then connect dash to the connectors .
on the car WITHOUT the BSI. Put the key to the ignition, but do not start!!!
just power on the dash. Dash value will self deletes.
After this connect the BSI and km value will be automatically loaded from BSI to dash.


I have no machine to dash record in alone xprog.

There is a trick to this car to dash is reset and take the new dump but I do not remember and did one and it was ok

[baze007]

I do not know about that trick ....... maybe someone else that knows this trick......It would be good and I would have learned

[hackbest]

have if anyone can help me on this issue thanks and regards

[hackbest]

Hello again anyone know how to reset the dash or trick to record the miles of bsi records in this case but alos removing contact returning originals.

[TOINO]

Good day mate, the process for this car is program the bsi, bsi let off after ignition without connecting panel to assume zero miles, turn off ignition and battery mount your voltal bsi battery without connecting the basement car! then start the car and should work even did this week! I have helped

[hackbest]

I do not understand you and fellow Spanish or explain me better or specify best

[bodzio012]

If your old mileage was 224162 km your new must working 100%, Put the key to the ignition, but do not start!!!
just power on the dash. Dash value will self deletes,

[hackbest]

if I have done but returns to take the 224,162 to remove the key and replace the ignition

[GolfmkI]

if I have done but returns to take the 224,162 to remove the key and replace the ignition

Not all NEC dashboard p307 erase mileage by powering on without bsi.

Last week I make one of them....must modify mileage on the NEC processor via Tacho v2008, Nec programmer, Upa or tool that you want....

All sw above 21 I think must be modified, older ones simple power on and mileage reset to 0.

That is the reason why you are obtaining again and again older mileage.