PDA

View Full Version : Golf 6 dtc erase



bugarcek
11th February, 2014, 11:46 PM
7286 - Turbocharger Boost Control Position Sensor Circuit: Implausible Signal
P2563 00 [237] - Short to Plus
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Mileage: 44867 km
Date: 2031.14.06
Time: 13:25:45

Is there any way to delete this error.... Car drives without a problem, but engine light lights.

arvedo
12th February, 2014, 12:12 AM
read ecu and publish here for your help

wiski
12th February, 2014, 08:08 AM
You should repair this error not getting it erased.

bugarcek
12th February, 2014, 09:15 PM
But how?? I replaced few vacum actuators and no sucess. Is there any way to adapt this sensor? Any measuring blocks to consider?

ohkarol
18th April, 2014, 04:00 PM
did you solve this problem ?

ruscic
19th April, 2014, 01:41 PM
You must adjust actuator if you change it.

ohkarol
19th April, 2014, 03:21 PM
You must adjust actuator if you change it.

how it should be done ?

ruscic
19th April, 2014, 07:03 PM
Click the „01 - Engine electronics“ button on the display.




The display indicates the control unit identification and the coding of the engine control unit.




Select diagnostic function:





Click the „011 - Measured values“ button on the display.





Use the numeric keypad to enter the block of measured values „120“ and acknowledge entry with the „Q“ key.





Connect hand vacuum pump -VAS 6213- to vacuum unit.





Observe the lowest value of the measured value block and set a voltage of 0.760 V by causing a partial vacuum.




http://www.digital-kaos.co.uk/forums/ElsaWin\html/images/Vorsicht.jpg Caution


During the following procedure for adjusting the control rod, keep the partial vacuum and thus the voltage of 0.760 V constant.







http://www.digital-kaos.co.uk/forums/ElsaWin\graphics\wi/N21-10174.png







Slowly screw the locknut-B- of the control rod downwards by hand. Adjusting lever is resting on the lower ?stop?.





Counterhold locknut-B- and screw securing nut-A- onto the control rod towards the adjusting lever. Tighten slightly with a ring spanner -T10423-.





Allow partial vacuum to escape from the vacuum unit.





Observe the lowest value of the measured value block. When there is no pressure, the value should be 3.30 to 3.90 V.





Fit 10 mm hexagon socket -T10422- or 10 mm hexagon socket -T10422 A-. Counterhold lock nut -B- with ring spanner -T10423- and tighten securing nut -A-.