View Full Version : Golf 6 dtc erase
bugarcek
11th February, 2014, 11:46 PM
7286 - Turbocharger Boost Control Position Sensor Circuit: Implausible Signal
P2563 00 [237] - Short to Plus
Freeze Frame:
Fault Status: 00000001
Fault Priority: 2
Fault Frequency: 1
Mileage: 44867 km
Date: 2031.14.06
Time: 13:25:45
Is there any way to delete this error.... Car drives without a problem, but engine light lights.
arvedo
12th February, 2014, 12:12 AM
read ecu and publish here for your help
wiski
12th February, 2014, 08:08 AM
You should repair this error not getting it erased.
bugarcek
12th February, 2014, 09:15 PM
But how?? I replaced few vacum actuators and no sucess. Is there any way to adapt this sensor? Any measuring blocks to consider?
ohkarol
18th April, 2014, 04:00 PM
did you solve this problem ?
ruscic
19th April, 2014, 01:41 PM
You must adjust actuator if you change it.
ohkarol
19th April, 2014, 03:21 PM
You must adjust actuator if you change it.
how it should be done ?
ruscic
19th April, 2014, 07:03 PM
Click the „01 - Engine electronics“ button on the display.
The display indicates the control unit identification and the coding of the engine control unit.
Select diagnostic function:
–
Click the „011 - Measured values“ button on the display.
–
Use the numeric keypad to enter the block of measured values „120“ and acknowledge entry with the „Q“ key.
–
Connect hand vacuum pump -VAS 6213- to vacuum unit.
–
Observe the lowest value of the measured value block and set a voltage of 0.760 V by causing a partial vacuum.
http://www.digital-kaos.co.uk/forums/ElsaWin\html/images/Vorsicht.jpg Caution
During the following procedure for adjusting the control rod, keep the partial vacuum and thus the voltage of 0.760 V constant.
http://www.digital-kaos.co.uk/forums/ElsaWin\graphics\wi/N21-10174.png
–
Slowly screw the locknut-B- of the control rod downwards by hand. Adjusting lever is resting on the lower ?stop?.
–
Counterhold locknut-B- and screw securing nut-A- onto the control rod towards the adjusting lever. Tighten slightly with a ring spanner -T10423-.
–
Allow partial vacuum to escape from the vacuum unit.
–
Observe the lowest value of the measured value block. When there is no pressure, the value should be 3.30 to 3.90 V.
–
Fit 10 mm hexagon socket -T10422- or 10 mm hexagon socket -T10422 A-. Counterhold lock nut -B- with ring spanner -T10423- and tighten securing nut -A-.
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.