Fiat Bravo 1998 1.9 jtd

[Blayders]

Hi. I have problem to read dashboard In fiat bravo 1.9 .
I do exactly like in nyo on foto and dont work .
Milage is in hc708az60 mask 3h62a . I used upa-usb .

[billykillkelly]

you i alvays desolder the mcu ... dont be lasy )))) it takes 10 mins....

[GolfmkI]

Perhaps could be readen by Upa in circuit but........is original or clone?

Dont you have adaptors.?? Desolder from pcb and read.....

Sometimes we have imposible to read MCUS, corrupted data, or even erased chips.........SIMPLE SOLUTION REMOVE CHIP FROM BOARD. I dont Know exact , if this mcu could be readen in circuit...

What is the error in UPA??

Vcc out of range????

Hope it helped.

[baze007]

Set oscilator 7200 then use button Auto baut rate when is finish with this option read mcu and all will bi ok........upa read perfekt this dash ...but must have correct pinouts

[Blayders]

I have orginal upa . I have only az60 , az60a/4mhz , az60a/8mhz . This is my upa UPA (UPA-USB)+hc912+nec + ZESTAW PLUGIN?W :: Programatory TOMSAD (http://www.programatory.com/index.php?p266,upa-upa-usb-hc912-nec-zestaw-pluginow) . I have also 5 boards but i don't now whit what it use :( . Upa get no errrs . Only driver not found .

[PETAR]

whit omega you can read in circuit but is beter out on bord this mcu
lift pin 2