0281012981 edc 16 c34 citroen picasso full

[jorge antunes]

hi

dear friends need to file uce 0281012981 edc 16 c34 citroen picasso full of BDM full original file and eprom virgem for coding lexia

I'm in error can because egr

help !!!

tanks

[giani03]

Post your ori dumps flash and eprom maybe help you.The car start bad and difficult only 2-3 seconds and engine cut off?

[jorge antunes]

no may frend
error data bus missing and esp abs and dirivad error engine recopy egr !
car sart ok and power its ok !

im put egr off not working

you have file a 100% ok orig full bdm

tanks

[proel]

Reflashing ecu will not solve your problem. Car ECU is not PC to reinstall new copy of windows! You must first find problem with egr or properly disable egr in flash. Write here DTC fault codes.

[jorge antunes]

hi

I need original dump,because i think i have a data problem inside ECU.
There is permanent DTC P0405- signal EGR too low. I measured it and it is from
0,25V to 4V .If I check EGR with Lexia in measured values there is showed -0%.

[jorge antunes]

egr its ok and new cables ok good and disable egr in flash prog ecusafe

help
tanks

[botchz]

hello sometimes ago i had the same problem.
The solutiopn is to change your ECU because out sw and le MCU of your ecu edc16c34 is corrupte.*
No solution with your existing ecu.
Untill you change the ecu you still have this dtc and you non not recode your injetrors code too.
best regards