Opel vectra c ,,swap ecu ?

[ttzag]

Hi all
Vectra c2008
Engine z22 se

Engine off every 5 minutes and never crank ,when I dis and reconnect battery,engine start for 5 minutes again.
Fault is p0601 ecu Rom error.
Is there a way to flash ecu again ?
If yes what tool to do it ?
Is it possible to read write on table by galletto or bdm ....etc ?
And if I need to swap it with a used one what tool can doit ?
someone can help with info about this fault please?

Thanx in advanced




Sent from my HTC One using Tapatalk 2

[Alpinesport]

You have to have a other ecu whit immo and vin number in you can read write on the table whit galletto power pins are wrong in doc
the fault in this is probably in can controller ( a82c250 ) or a bad connection ( solder )
test the ground wire to ecu ( big one ) if you need power connection tell me

You need the code and a opcom to use a old ecu

[ttzag]

The trouble came after mouse eat some wires under wipers ,
I resoldered all wires and check it again and again, all is ok.
After engine stop if I reconnect battery cable or ecu connector or ABS connector ,car start again .

Can u give me a connection for ecu ?
And connection for galletto on table?
If I need to swap ecu, can op_com clone do it ?


Thanx in advanced

Sent from my HTC One using Tapatalk 2

[Alpinesport]

this is working

Bild:Trionic8.jpg - OBD-Wiki (http://wiki.obdtuning.com/?title=Bild:Trionic8.jpg)