Insignia Dash -------

[z786]

Hi,
got a insignia here, customer removed a few fuses, now there is no mileage displayed, i can read via obd but not on clocks, iv even adjusted but still no joy.

clocks just show dashes -------

any ideas?

thanks

[ruffles1986]

try to reset dash with pin,and program again, i not work with this dash but this is "my idea"

[smartymarti]

You could do it by EPROM and not obd as sometimes it dosnt write correctly , iv seen this on various vehicles

[honingkoning]

I can remember when car came out enigma they did not wright the bottom line correct , maybe this went also wrong.

like smarty said try direct maybe this will solve problem.

[z786]

car hasnt been corrected, jus fuses removed.any other ideas before i strip?

[Lexas]

car hasnt been corrected, jus fuses removed.any other ideas before i strip?

upload your dash dump please, ill try to fix it. have done one with same problem month ago, or you can do it yourself. here dumps for everyone, NO PASS
just must say, dumps are in miles from uk car clocks.

[borysgo2]

Lexas
Thanks for the dump. Work like a charm.

[garagetech]

upload your dash dump please, ill try to fix it. have done one with same problem month ago, or you can do it yourself. here dumps for everyone, NO PASS
just must say, dumps are in miles from uk car clocks.

hi pal is there a need to change pincode? or car start after upload?

[Lexas]

One dump bad with ----- another fixed. Compare dups for diference and change your original dump like this, so you dont need change vin or pin. My dumps is for example how to fix problem. Good luck

Sent from my SM-G928F using Tapatalk

[garagetech]

One dump bad with ----- another fixed. Check diference and change your original dump like this, so you dont need change vin or pin. My dumps is for example how to fix problem. Good luck

Sent from my SM-G928F using Tapatalk

Vin changed chip programmed installed cluster now, car started with dump mileage. later automatically synced to bcm job done

Thanks pal

[ignite]

Hi Lexas,

I have compared the two example bin files in hex. I can see a hell of a lot of changes when I do a difference between the two. Please could you confirm if this is the case? Thanks in advance.

[ignite]

I'm still at a loss here, can anyone help please?

22 differences: 46 bytesAdded(14)Deleted(14)Changed(18)

390445

[Lexas]

I'm still at a loss here, can anyone help please?

22 differences: 46 bytesAdded(14)Deleted(14)Changed(18)

390445
just put same values in the same places as in fixed dump, and miles should show up.

[looly]

I'm still at a loss here, can anyone help please?

22 differences: 46 bytesAdded(14)Deleted(14)Changed(18)

390445

Which hex editor is that pls?

[ignite]

Which hex editor is that pls?

Hi mate, examdiff pro

but you can also use notepad++

[ignite]

Last question, could I use op-com to do this or is this a cluster out and desolder eeprom job ?

[davecooper47]

Thanks Lexas. There are 2 dumps here obviously. Do I presume correctly that the one with mod in the title is the fixed one?? Thanks. Dave.

[urcarpc]

yes, the mod one is the fix

[Meat-Head]

ON TOPIC:/

thete is another thread like this, think was started by "captin crackers"