atd
28th March, 2014, 03:31 PM
Hi,
I need to remove throttle flap / dtc P1125 because of "limp mode" and "Mil On" sometimes.
I attach ori file readed by Mpps ( genuine MagPro2 did not read). Winols see bad checksum but comparing to original bdm file it looks good (it's often with edc16 opel ecus readed by mpps).
It's Zafira B 1.9cdti 120hp EDC16C9
P1125 -Throttle Actuator
Tried to find error patch block start: at C850E but I'm not sure if its correct start bit???
I also suppose start error code block at C81FE but I'm not sure.
Somebody have good damos or working DTC Remover or manual solution?
Please help to do this.
Regards
I need to remove throttle flap / dtc P1125 because of "limp mode" and "Mil On" sometimes.
I attach ori file readed by Mpps ( genuine MagPro2 did not read). Winols see bad checksum but comparing to original bdm file it looks good (it's often with edc16 opel ecus readed by mpps).
It's Zafira B 1.9cdti 120hp EDC16C9
P1125 -Throttle Actuator
Tried to find error patch block start: at C850E but I'm not sure if its correct start bit???
I also suppose start error code block at C81FE but I'm not sure.
Somebody have good damos or working DTC Remover or manual solution?
Please help to do this.
Regards