View Full Version : BMW E39 DME MSS52 IMMO OFF
tiguan
7th April, 2014, 06:39 PM
BMW E39 DME MSS52 IMMO-OFF
Can anybody help me with immo off?
Need working ecu without EWS. read with Galletto V53
thank you.
easytech
12th April, 2014, 12:13 PM
Here is your immo off file,
255347
lolilocortachispas
25th August, 2014, 03:24 PM
i need the pass for car with the same problem, really thanks
baltazar3
25th August, 2014, 07:42 PM
i need the pass for car with the same problem, really thanks
First post Your dump here
easytech
25th August, 2014, 10:14 PM
Everybody post YOUR ori file.
lolilocortachispas
26th August, 2014, 10:53 PM
hi guys, my interface can not read by obd, in the picture, which is the memory that I have to read?
thanks
274556
lolilocortachispas
28th August, 2014, 10:14 AM
can anyone help me? thanks
easytech
29th August, 2014, 01:44 PM
You need the right in youre picture. With Galetto1250 you cab read/write it on the table.
kugglefischer
29th August, 2014, 02:05 PM
Here is your immo off file,
255347
PM sent.....:top:
lolilocortachispas
29th August, 2014, 06:32 PM
thanks easytech, i go to read it and upload
lolilocortachispas
1st September, 2014, 12:29 PM
this is the right file,thanks
275302
easytech
4th September, 2014, 08:27 PM
Here is your file
lolilocortachispas
5th September, 2014, 02:44 PM
hi easytech, really thanks, the car start perfectly but after 5 or 6 seconds print motornotprogram on the dash and don't accelerate, is in protection mode
there are 3 dtc in dme:
exaust temperature sensor
no comunication with ews
internal error
i program the memory with willem, the checksum is correct?
thanks
easytech
6th September, 2014, 04:14 PM
The checksum was not corrected yet!!
No comm with EWS is normal
Exhaust temp is not connected?
speedy100
6th September, 2014, 10:13 PM
Hello,
Total immo off i believe is not possible...
Only Virgin file that needs checksum correction before programming back to the Flash.
Then the ECU needs to be adapted with diagnostics tool.
Best Regards
easytech
8th September, 2014, 10:27 PM
No, it is 100% standalone no need for any adaption.
If you keep the EWS then you will have to bypass the starter and get 'EWS manipulation' error but still car runs normal.
jolidj
3rd December, 2014, 01:45 PM
hi. immo off please.
jolidj
4th December, 2014, 01:25 AM
help please
Baddog84
4th December, 2014, 02:58 AM
hi. immo off please.
test and report
pass pm
easytech
5th December, 2014, 11:44 PM
This is your immo off,
Pass in PM
289421
Bendiberin
7th September, 2018, 09:01 PM
Это ваше immo off,
Pass in PM
Please give the password
i_shot_the_sheriff
22nd December, 2018, 08:26 AM
Hello mates
Is it possible to make immo off on this one too? Ecu is 5WK9315 7832785 with 29F200 and car has EWS3 ! I have read the right flash with programmer
Do i have to connect ews wires after?
Thanks in advance
i_shot_the_sheriff
27th December, 2018, 07:04 AM
Anyone please?? :)
i_shot_the_sheriff
31st December, 2018, 06:58 AM
Willing to pay for a solution :)
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.