Ford Focus FAP problem

[AC_SHNITZER]

Hi friends , I have problems with Fap remove of Ford Focus 1.6tdci 110hp ecu nr:0281012487 sw:390500 . I know but try with Ecusafe and Volta but problem still present , no dtcs at all but car is in limp mode . I read that is manual solution with change one bit from 01 to 00 but question is where is it in hexdump in what adress ??? Any help please !

[AC_SHNITZER]

No one ???

Sent from my GT-I9505 using Tapatalk

[blazej1200]

1E784A 01 to 00

[AC_SHNITZER]

i changed this bit , car is working but still limpmode , tryed to disconnect additive module and diferential sensor but nothing , i have the problem with fuel additive can and there is no additive on it , may this cause a problem ?

[blazej1200]

you need to I reset content of ash

[AC_SHNITZER]

only that or replace broken additive can too ? it is possible to manual reset in eeprom like in vag cars or only with manufacturer specific tester ???

[ominimicu]

reset DPf in ecu and BSi my friend. If not somemaps need dleteing...its not aalways just a switch to flip....

[AndrewW]

that good solution worked 100%

[AndrewW]

you can disconect pressure sensor if you wnat,worked 100% never ever any problem

[AC_SHNITZER]

this looks like a volta but i try in tuesday an tell if it works

[AndrewW]

thats not volta,it will worked

[AC_SHNITZER]

I will try tomorrow and report

Sent from my GT-I9505 using Tapatalk

[auto421]

work 100% very good tanhk you

[Meat-Head]

What hardware did you use to read/write plse

[Babos]

i look dpf file and he is totaly wrong :D

[AC_SHNITZER]

Not work for me , can start the car . I find dpf switch but limp mode is still active . Tomorrow i have customer for chiptuning with same car but without DPF and i try to write this file to problematic car and see what hapeend

Sent from my GT-I9505 using Tapatalk

[digi men]

HY
you made the one swith solution, and try Modify the overboost :joyous:

[Meat-Head]

Don't think this will help BUT.

had two hocus pocus with faulty fap sensor, but left an unclear able code.

unplugged the new sensor this caused another fault, left unplugged, cleared. Cane back of course. Plugged in new sensor, cleared then happy.

[Babos]

i know where is problem. you try solved one problem but car have one more problem ;)

[AC_SHNITZER]

i know where is problem. you try solved one problem but car have one more problem ;)

Ok , tell whwre is the problem :)

Sent from my GT-I9505 using Tapatalk