PDA

View Full Version : 2014 Toyota Fortuner Immo Help...



Hanukkah
17th April, 2014, 04:05 AM
Engine ECU is 89661-OKXXX

Is there an immo off for this?

Cannot locate immobox with 89780 part number behind or below dashboard or behind glove compartment.

Thanks in advance...

iamfooser
17th April, 2014, 04:09 AM
Key system or proximity?

Hanukkah
17th April, 2014, 04:15 AM
Key system or proximity?

Hi still using Toy43 3B Remote key... "G" stamped on key blade mate.

iamfooser
17th April, 2014, 04:18 AM
Did you try looking for it behind blower? Not possible to do immo off as I know.

Hanukkah
17th April, 2014, 04:31 AM
Did you try looking for it behind blower? Not possible to do immo off as I know.

Will see if there is immobox behind blower... Thanks

Hanukkah
17th April, 2014, 10:11 AM
Found immobilizer after removing dashboard. Behind center blower louver (a few cm below windshield) mounted to firewall. Cannot miss it as there is a wire harness...

Immo part number is 89780-71030

Anyone can help reset this so I can add the 2 oem keys. Thanks.

iamfooser
17th April, 2014, 10:26 AM
Great. Can you please kindly take a pic of the location?

As for the immo, we will have to wait for our expert. I think you will need to post key data.

siyadk
17th April, 2014, 11:57 AM
ya a picture will be great and the part number

gwee
17th April, 2014, 12:20 PM
ready to add key :)

iamfooser
17th April, 2014, 12:26 PM
Here comes our expert. Hahaha

Hanukkah
17th April, 2014, 01:20 PM
Thanks gwee...

BTW, what is procedure for adding key?

gwee
17th April, 2014, 01:24 PM
you will need key with pg1 - 36 or 56.

if u are adding 2 keys, i think first u have to insert first key, wait for few seconds then pull out,

insert the second key and turn ON OFF 5 times quickly to close the learning mode.

iamfooser
17th April, 2014, 01:32 PM
If it is like usual, the immo light should stay on when you plug in the immo box. As you insert the key, light will blink once and continue to stay on. Insert another and it should blink again. After closing the learning procedure, light will blink like normal. Not sure if it is the same for this car.

Hanukkah
17th April, 2014, 01:43 PM
Many thanks gwee and iamfooser...

Will do this tom and report how it goes.

Thank you brothers =)

achaccha
17th April, 2014, 05:50 PM
Try an report. please disconnect the immobilizer or cut communication to the ecu immo
pass: mp

Hanukkah
19th April, 2014, 08:59 AM
Try an report. please disconnect the immobilizer or cut communication to the ecu immo
pass: mp

Sorry mate... RH86 eeprom must be OTP. Cannot write the dump you sent, only original dump.

Did gwee's immo-reset and working add key.

Thanks a lot.

CLK1201
19th April, 2014, 09:09 AM
use xprog 93xx86b can write this eprom . i write already

gwee
19th April, 2014, 09:11 AM
===========

abdo30
2nd May, 2016, 11:00 PM
i have immo off about ecu

abdo30
2nd May, 2016, 11:07 PM
i think the hilux 2014 immobilizer same thing

marcustee79
1st July, 2020, 09:19 PM
can i have the pass please

alnasya
23rd February, 2021, 05:58 PM
Tolong beritahu saya mengenai immo toyota fortuner dengan cara melewati sistem immo..saya tidak.akan mempergunakan nya ..karena dengan kunci biasa saya lebih mudah

alnasya
23rd February, 2021, 06:00 PM
Bisakah anda memberitahu saya..terima kasih

alnasya
23rd February, 2021, 06:02 PM
Bisakah anda memberitahukannya ..cara memutus immo ..apakah ada kabel yang dijumper...