How to clone Opel EDC16C9 ECU ?

[aqua_life]

Hello,

Opel Vectra C 1.9 150hp. ECU number 0281011914.
This ECU is faulty (camshaft sensor error, wires were broken and made a short circuit).

I bought a used ECU and I want to clone it.
I searched and it seems that this ECU has eeprom 95160. I can?t find this eeprom in bottom ECU.

If I change eeprom content from one ECU to the other, it will be OK ? Car is far away so it is more difficult to virginise and program.

One more question. I tried to connect the ECU on bench with AVDI and Carprog, but I can?t connect. I am using this connection diagram:
Opel ECU by CAN programmer - read/change mileage in EDC16 (http://www.codecard.lt/carprog/software/opel-ecu-by-can-programmer-read/change-mileage-in-edc16-mt35e-hsfi-2-2-me7-6-2-read-pin-reset-ecu/prod_334.html)

Thanks for your help

[darius89]

Only bdm you can clone 100% flash and eprom

[aqua_life]

Ok. Thanks for your answer.
I have Galletto V54 Portuguese clone. But I don?t have BDM adaptor for this ECU.
Can you please tell me pinout ?
Please check this image. You have Galletto pinout and ECU pinout. How should I connect it ? I can solder wires in ECU...


http://s24.postimg.org/s3my97j1d/fgtech.jpg (http://postimg.org/image/s3my97j1d/)

[gttuning]

its all in manual!

[PIC18F2550]

yes is good connect i use same connect with Galletto v48 Portuguese clone connect only (vfls0/dsck/gnd/hreset#/dsdn/dsdo ) and power 2x12V from external power