PDA

View Full Version : Crafter edc16cp34



VDO
10th May, 2014, 06:42 PM
Hi can someone check these file is it OK and are the DPF removed from damp
Thanks

immokill
10th May, 2014, 07:15 PM
Yes it is switch solution on 1D4378

velindro
10th May, 2014, 08:15 PM
i think with this file you will get in trouble,because timer still on,sooner or latter you will see!
try this one,timer and pressure switch off!

VDO
10th May, 2014, 10:20 PM
With first dump I make also reset of ash with diagnostic on option for new filter add ,@velindro at the end maybe I put your damp on ecu to be sure for right job done thanks mate

velindro
11th May, 2014, 08:33 PM
With first dump I make also reset of ash with diagnostic on option for new filter add ,@velindro at the end maybe I put your damp on ecu to be sure for right job done thanks mate

your pm box is full
cant send anithyng

VDO
13th May, 2014, 06:53 PM
No it is not full I got from you PM on 10th May ,Thanks again

VDO
14th May, 2014, 06:14 PM
Hi i have these error now P1040 when I start engine work for 3 sec then goes off if i start engine and press and release throttle pedal above 1500rpm then stay to work normal what can be problem?

velindro
21st May, 2014, 12:24 AM
what file did you put in car?
switch solution?

ominimicu
21st May, 2014, 10:08 AM
These ecu must be BDM ed always and do just 2 switches solution. all sensors conected and working!

kennfeld
21st May, 2014, 11:46 AM
they also work obd
but not all can been read if ecu programmed in 2011 then you can't read or write obd because it's looked flash enable is off

VDO
22nd May, 2014, 07:05 PM
I read it with obd but when i try to write it crash on 29% and brick the ecu then I must to to read-write with BDM but i still have problem with error on both files switch solution and yours @velindro