Opel Astra 2012 denso 1.7 dont start after read ecu.. help please.

[jolidj]

hi friend , i have big problem whith this car.
i open the ecu and solder all pin wire to read it.
all ok , file read ok, is good file and see dpf is remooved , close the ecu but car dont start, wen i try to start dash shut off and dont comunicate whith ecu from diagnostic .
i try to reconnect all whith galletto and all is ok, i can do all i need whith ecu , id read write but car dont start.
any idea please??? if possible to reprogram scrap ecu to opel office??
post image from ecu can anyone tell me if r412 is emty ore have resistor??
thanks for help. all idea please.

[ruffles1986]

Hi mate, yes you must put r102 value in place R412

Enviado desde mi GT-I8260 mediante Tapatalk

[arvedo]

piasini read bdm is ok ,read manua
l

[jolidj]

thanks. my problem is not to read and write ecu , i have ori galletto.
problem is ... r412 what value have??? becouse i dont have it in my ecu, maybe i desolder and louse it.
help me please.

[ruffles1986]

thanks. my problem is not to read and write ecu , i have ori galletto.
problem is ... r412 what value have??? becouse i dont have it in my ecu, maybe i desolder and louse it.
help me please.

I answer you, you lose a resistor in the place what you marked in photo, put a resistor 102-1000ohm in the place R412.

Maybe you dont stand me, 102 is the number marked in resistor, 102-1000ohm.

R412 is the place marked in PCB to allow the resistor

Enviado desde mi GT-I8260 mediante Tapatalk

[jolidj]

yes i dont read r102 .....

all ok. i change r412 with 1k resistor all ok. car start....
im so hepyyyyyyyy.
thanks all friend .
best dk forum.