PDA

View Full Version : Punto 2001 key programming.



honingkoning
24th May, 2014, 09:29 PM
Guys i need to add a key to a punto 2001 ( all keys are lost) i Will open bcm and extract pin with zed bull, and program key with autocom.
My question i am out of transponders so could i use a transponder from a donor Car?
Or is it possible to add transponder to bcm?

If yes could someone tell me how to add this one.

Wbr Adam.

Meat-Head
24th May, 2014, 09:52 PM
Err wicked short answer is no, no and no BUT.

if you get a bucket full of keys, you find some say magic 1 some say magic two.

the rare magic two you can unlock with see bill.zed bull (iShit Failiure) ..

THINK pin code twice in dump look for line 6 down ends b0. Then laughing say

07 34 56. Code 73456 example.

furst byte of dump 93c66 02 number if keys then the keys are byte swapped.

i played with myself once, tried to Add used key for fun. BUT car had magic 2. Key I had was magic one ..

PLEASE keep thread updated as u have a fettish for shit like this.

or immo off if you have the gear, stuff up key light, boo hiss.

honingkoning
24th May, 2014, 10:47 PM
[emoji1] I really have fettish for this kind of shit.
Immo off is ne pas possible ecu is iaw59f.
I do have gear for virgin/off but Car Will start only once [emoji20].

Thanks guys any suggestions are welcome.

Meat-Head
24th May, 2014, 11:12 PM
Ah what do you use to flash ecu with (another one if my fetishes) ..

sadly my dumps are not on my, the paper I used was used for paper areoabs.

i THINK byte swapped. Key was AB B3 E6 48. In dump B3 AB. 48 E6.

something like. It was a car I stole, ripped out EVERY last wire, got the lot, then stashed the loom Bcu ecu etc, my plan (iShit Failiure). To is to nail thus bastard uShit to a yellow submarine.

thrn screw loom ecu bcm clicks to a piece if plywood for a family heirloom

simaservis1108
25th May, 2014, 12:32 AM
You can program used transponder,but you will need to unlock it first.Magic II can be unlocked with almost all better tools.Magic I only with Tango.

obdsystems
25th May, 2014, 12:35 AM
With avdi (or other kit) you can read engine ecu and switch off immo

or

with transponder chips (megamos) you can write new to bcm eeprom.


And no you can't use chips from donor car. the chips are ?2.50 for a job you can charge ?160 for. Do the maths !!!??? :)

Meat-Head
25th May, 2014, 10:27 AM
And no you can't use chips from donor car. the chips are ?2.50 for a job you can charge ?160 for. Do the maths !!!??? :)

True but if its a car you have stolen and some used keys you shoplifted from Walmart, late at night in your own, who cares.

Quote:- OBDMASTER

trsndponders are cheap my m8 vehicle recovery is expensive

cleevesy
25th May, 2014, 10:30 AM
Just read 93c66 in Bcm and code to TP08 start car ,no need to program in via diagnostic

I Never bypass the immo unless absolutely necessary

Meat-Head
25th May, 2014, 10:41 AM
Cool what about check sum and rolling code and the security code ID48!?

gokey
26th May, 2014, 06:51 AM
is it possible to add transponder to bcm?






zed can add transponder to dump
image file