VW TOURAN 2005 dsg 1.9tdi bkc. problems after rewriting

[martis27j]

Hi everyone , i have problem with car. Try to fix hot start, but some thing happen. after writing i get error on dash. and fault code Glow Plug Control Module- Implausible Signal. Then i try write same orig dump, but don help. try to find what wrong with winols, don't find, looks everything good. glow plug relay is good and plugs are new. this problem come right then finish flashing.
I hope some one can give right direction. her is two, one org. and one who make this mess. Thank you.


263006 263007

[Baddog84]

Hi everyone , i have problem with car. Try to fix hot start, but some thing happen. after writing i get error on dash. and fault code Glow Plug Control Module- Implausible Signal. Then i try write same orig dump, but don help. try to find what wrong with winols, don't find, looks everything good. glow plug relay is good and plugs are new. this problem come right then finish flashing.
I hope some one can give right direction. her is two, one org. and one who make this mess. Thank you.


263006 263007


test and report
pass pm

[Romaus]

test one of this files PASS PM

[ominimicu]

file looks ok must be a checksum correction issue
waht tool u used for flashing?

[martis27j]

HI same problem. but fault code is 17068-glow plug control module (j271):implausible signal.

[angelx431]

Answer! What tool used for flashing?

[martis27j]

First was mpps. this make problem. and now try my friends kess v2. clone. he newer have some thing like this, with writing and reading. we also think is checksum. but same with his. And it was made many cars without any problem. I was aspect today finish with this, headache.

[ominimicu]

If u flash back ORiginal it all goes ok? an dno glow error?
if not then it s a corrupt eeprom issue

[martis27j]

Yes from begining i try recover with org. but same error. Also i was think maybe damp , when i read was coruptet. then i lose possibility go back to org. but everywhere everyone check dump and tell, looks ok, should be good.
Its be really, good to have some idea how to fix this. The car running good, starting also better after flashing, just i see it using apron. 1l more fuel.

[angelx431]

(MPPS) Yes eeprom 95... problem! Change dump and synchronization.

[martis27j]

Maybe some one have good dump. Also maybe is better to do this job on the table? not by obd.

[ominimicu]

of course u have to do this via BDM to read eeprom.
give exact ECU data so we can search for a eeprom , which u must sync key again or do immo off

[angelx431]

[QUOTE=martis27j;2311361]Maybe some one have good dump. Also maybe is better to do this job on the table? not by obd.[/Q
Good writ BDM port.

[martis27j]

Thank you for everyone. I begin on that way.