honda civic 1.5_16v 105cv ecu oki

[gezame]

Hi
Car, honda civic 1.5_16v 105cv ecu oki.
Anyone have solution for immo off in this ecu oki:
37820-P9L-E13
I test remove pcb with chip oki M851G, no work.
I test change the dump oki M851G to FFFFFF,no work.
I post pics for ecu, and pcb with chip oki.
Thanks in avance.
Br.

[aslamaslam]

remove pcb this is the solition

[gezame]

Hi
I make test remove pcb with chip oki M851G, but do not work.
I test change the dump oki M851G to FFFFFF,no work.
Br.

[Meat-Head]

WHIA. 1) ebay ?10 emulator board
2( you did shirt out strarter?
3) remove board wait 10 seconds then crank
4) remove mil if you did 3)

[gezame]

Hi
I think need emulator, but in instructions see is for other ecu type, not for this.
Br

[alclot]

Hi gezame. I have same problem. Do you solve immo off?
Thanks in advance ;)


Hi
I think need emulator, but in instructions see is for other ecu type, not for this.
Br

[tqnata83]

Honda cars year 1995-1998 (Civic, Accord and others). Inside immo board looks
like in picture. On this board is small 44pins processor and OKI M851G EEPROM
(you can read/write it like 93C46)

in this case remove bord and car start

Honda cars year 1999-2002 (Accord, CRV, Civic and other). On this board is 28pins processor with label HONDA HIS

in this case remove board and solder emulator or MAKE KEY

[aslamaslam]

no need to emulator
remove the bord tested 100000000%

[Meat-Head]

no need to emulator
remove the bord tested 100000000%

Yes but if you don't wait fir a few seconds crank it like your shaking a Polaroid picture

[okura]

for this ecu no need emulator,

[aslamaslam]

...........................yes

[javyb]

How do you read oki chip as 93c46? Aby pinout please

Sent from my SM-G935F using Tapatalk

[Meat-Head]

Yes put on adaptir read as 93C46
if you have time replace with 93C46 for a laugh.

fill with FF for vergin still need emulator sugnal, bro

[miha99]

Yes I can confirm; short out strarter and remove pcb with chip oki M851G did the trick, no need for emulator or programing eprom !!!

[r1lef]

Hello same problem on Prelude 2.0 97 ! i removed the immo PCB and don't work !! i go to test with FF in M851G ...

[chipcarcordoba2]

Hi, I have the same problem and I do not give with the key, Emulator does not come the manual. removing PCB does not work, removing inmobox nothing. Is there any good solution?




thanks and regards

[chipcarcordoba2]

Do you have to do something to start engine?

[chipcarcordoba2]

please... should I do something to the starter so it can start?