BMW LCM III HELP reading 3D64J

[autodigitec]

I've tried to read in circuit with xprogm 5.0, upa and carprog.

No success with any of them yet.

Anyone knows which pins I should lift or if I need to change oscillator?

[captain crackers]

Never done this LCM this way but for HC11PH8 micro using the UPA, lift pin 72 no need to change the osc. Possibly you will need to warm the micro with hot air. Arthur.

[ecupro]

Do you have tool for OBD, 2 minutes with obd. I am always done this with BMW scanner.

[autodigitec]

I have bmw scanner e6x and bmw scanner 2.20, car has old bmw plug, both scanners fail trying to connect with cas (which it doesnt have).

With upa I already tried lifiting pin 72 as it says in guide, with and without changing oscillator. No luck. All voltages are green on pins.
I might try using hot air on it later today.

I want to clone, not change km.

[ecupro]

Which BMW is that, e46?

[ecupro]

Here is how you can done this without remove LCM, try again, good luck.
265037

[autodigitec]

Car model is e39.

I dont have interface for scanner 1.4, unless e6X interface works with that software.

[ecupro]

I have only 1.4 Scanner and LCM work perfect mileage, vin, and other function.

[anda2003]

Hallo .
Here a photos how to connect LCM to programmer without any lift pins or desoldering ( Works 100% )
Greetings .

[Diagcar1]

Hallo .
Here a photos how to connect LCM to programmer without any lift pins or desoldering ( Works 100% )
Greetings .

A 5 year old topic, think they solved the problem already.

[tordu]

Hi,
be in december 2020 and thanks to anda2003 for the reply ;)