Need pinout e46 320 2002

[hackbest]

Hello I have to make a bmw e46 320 2002 and I need pinout LCM, EWS


to do force the wing LCM and EWS?


35080 alone is not sufficient to


please someone helps me out

[ecupro]

The best way to do LCM is BMW Scanner via OBD if you have, for this m35080 you don't need special programmer x-prog, carprog can erase, this is bosch cluster remove needles is easy, for EWS you can use X-prog, for some EWS you can use Carprog.
And yes you can program only dash-m35080, km won't jump, but with diagnostic it will be there in EWS and LCM.

[hackbest]

I have only xprog and r270
need pinout of LCD and EWS

[ecupro]

You can done job with x-prog, some ews can be done by k-line, some is necessary to desolder and read in adapter, what is mcu inside and what hw and sw version?

[hackbest]

BMW LCM - 68HC11PH8 - 2003 year

BMW EWS3 MODULE SW 08 - 68HC11EA9 - 2003 year

[hackbest]

wing force must be done in the three siteos 35080, LCM, EWS ?

[ecupro]

I can't understand you, but you will probably ask is it necessary to do in this 3 location, you can do only dash, but for good job better is to do all modul, probably your EWS is hw03 sw08 mcu od46j if is that ews, you can use your ews adapter from xprog, connect modb like in picture, for LCM I am never done this way only OBD, but if you wan't to do only dash, do dash, regards.