EDC7 EURO3 Need full BDM

[ODBlue]

Hello mates

I have EDC7 EURO3 and I Have X-prog and other programers, the problem in MPC556, I Need to change it with

empty one, so I just wondering if we can use it empty then connect the EDC with MAN online to upgrade it ? I don't

know if that possible ? or any one have the pin point for that EDC if I want to read the damaged one or if I can get

good EDC to read it and copy the software then write it into the new chip ? or if some one have full software that will

be so good and helpful !!

I will appreciate that so much

[chiptorque]

Here is a EDC7. hope to help

[chiptorque]

Here is a EDC7. hope to help

[ODBlue]

Here is a EDC7. hope to help

is that working files 100% or not sure ? its not easy to work woth that EDC

thank you so much

[ODBlue]

plz any one have pin out for this EDC ?

[ODBlue]

VFLS1, VFLS0, RESET, DSCK, DSDI,DSDO, GND

I know the pins on micro controller by using schismatic for MPC556 but its not easy to pull it out and reinstall

[insomnia2009]

Have you got bdm frame to try read mpc and see what software number is there compare to the file that was posted here

Sent from my GT-I9505 using Tapatalk

[ODBlue]

Have you got bdm frame to try read mpc and see what software number is there compare to the file that was posted here

Sent from my GT-I9505 using Tapatalk

not yet my friend, but flash inside MCU should end at 0x00000 - 0x6FFFF, and the file above first one end at 0x6FFF0, and other file at 0x700F0, I don't know if that correct or not

[insomnia2009]

I see what you mean did you did you try read old mpc with bdm

Sent from my GT-I9505 using Tapatalk

[ODBlue]

I see what you mean did you did you try read old mpc with bdm

Sent from my GT-I9505 using Tapatalk

thank you so much for reply, not yetm I pull it out then I identify programing points 7 points, but the short circuit inside the microcontroller so I don't know if can read it or not!

thank you again

[insomnia2009]

No you wont be able to read if mpc is the short how are you trying to read mpc by the ball points

Sent from my GT-I9505 using Tapatalk

[ODBlue]

No you wont be able to read if mpc is the short how are you trying to read mpc by the ball points

Sent from my GT-I9505 using Tapatalk

no my friend i tracked the pin point by the solder points and data sheet