View Full Version : EDC7 EURO3 Need full BDM
ODBlue
26th June, 2014, 09:36 AM
Hello mates
I have EDC7 EURO3 and I Have X-prog and other programers, the problem in MPC556, I Need to change it with
empty one, so I just wondering if we can use it empty then connect the EDC with MAN online to upgrade it ? I don't
know if that possible ? or any one have the pin point for that EDC if I want to read the damaged one or if I can get
good EDC to read it and copy the software then write it into the new chip ? or if some one have full software that will
be so good and helpful !!
I will appreciate that so much
chiptorque
26th June, 2014, 12:21 PM
Here is a EDC7. hope to help
chiptorque
26th June, 2014, 12:27 PM
Here is a EDC7. hope to help
ODBlue
27th June, 2014, 12:35 PM
Here is a EDC7. hope to help
is that working files 100% or not sure ? its not easy to work woth that EDC
thank you so much
ODBlue
28th June, 2014, 01:11 PM
plz any one have pin out for this EDC ?
ODBlue
28th June, 2014, 02:11 PM
VFLS1, VFLS0, RESET, DSCK, DSDI,DSDO, GND
I know the pins on micro controller by using schismatic for MPC556 but its not easy to pull it out and reinstall
insomnia2009
28th June, 2014, 02:15 PM
Have you got bdm frame to try read mpc and see what software number is there compare to the file that was posted here
Sent from my GT-I9505 using Tapatalk
ODBlue
28th June, 2014, 03:58 PM
Have you got bdm frame to try read mpc and see what software number is there compare to the file that was posted here
Sent from my GT-I9505 using Tapatalk
not yet my friend, but flash inside MCU should end at 0x00000 - 0x6FFFF, and the file above first one end at 0x6FFF0, and other file at 0x700F0, I don't know if that correct or not
insomnia2009
28th June, 2014, 04:00 PM
I see what you mean did you did you try read old mpc with bdm
Sent from my GT-I9505 using Tapatalk
ODBlue
29th June, 2014, 05:23 PM
I see what you mean did you did you try read old mpc with bdm
Sent from my GT-I9505 using Tapatalk
thank you so much for reply, not yetm I pull it out then I identify programing points 7 points, but the short circuit inside the microcontroller so I don't know if can read it or not!
thank you again
insomnia2009
29th June, 2014, 07:11 PM
No you wont be able to read if mpc is the short how are you trying to read mpc by the ball points
Sent from my GT-I9505 using Tapatalk
ODBlue
30th June, 2014, 11:10 AM
No you wont be able to read if mpc is the short how are you trying to read mpc by the ball points
Sent from my GT-I9505 using Tapatalk
no my friend i tracked the pin point by the solder points and data sheet
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.