PDA

View Full Version : PICASO!!! 2.0 HDI 0281011521 HELP PLEASE!!



shanektm450
27th June, 2014, 07:27 AM
OK I GIVE UP THIS CAR IS THE WORST EVER MANAGE TO CODE ECU AND WHEN I TURN IGN OFF AND ON IT IS LOCKED!!!! NOW I NEED TO PUT IMMO OFF AS I THINK ECU HAS COMMS FAULT WITH BSI I CANT GET A SET ANYWHERE OR JUST A ECU ,BELOW IS THE SERIAL 5P08C3 AND AM29F400BT HOPE SOME ONE CAN HELP
CHEERS
SHANE

tqnata83
27th June, 2014, 07:43 AM
ecu whit 1 plug or 3 plug?

shanektm450
27th June, 2014, 08:25 AM
HI SORRY IT IS 3 PLUG
CHEERS
SHANE

cfgebel
27th June, 2014, 10:42 AM
.............your file off............

shanektm450
28th June, 2014, 07:23 AM
.............your file off............
Thanks file worked 100% but stays in econo mode and need to know what is problem , normaly I just put ECU into aftersales services and programe pin and car starts eeprom in BSI is 95160, any help would help
Cheers
Shane

cfgebel
28th June, 2014, 11:04 AM
the 2 file reseaux can must verify


bsi =======================/============ ecu

metercar
28th June, 2014, 09:24 PM
if the car is with ABS verify CAN lines in-out from this unit

betrescudan
28th June, 2014, 09:37 PM
Thanks file worked 100% but stays in econo mode and need to know what is problem , normaly I just put ECU into aftersales services and programe pin and car starts eeprom in BSI is 95160, any help would help

sorry---i do not understad....after start engine for 15 minutes,is ok if the car enter on ecconomy mode...let engine running 1/2 hour for 10 minutes autonommy...after that-----ecconomy mode

metercar
28th June, 2014, 10:29 PM
ECO mode and engine run then no CAN comunication BSI-ECU, verifiy telecode on ECU if this is BSI multiplexed or not, test ECU and BSI CAN lines on bench

shanektm450
30th June, 2014, 05:45 AM
Thanks for reply , so I must check can from ecu to BSI , If I get Can to ECU then I have A ECU problem I will check and reply
Cheers
Shane

shanektm450
30th June, 2014, 05:46 AM
ECO mode and engine run then no CAN comunication BSI-ECU, verifiy telecode on ECU if this is BSI multiplexed or not, test ECU and BSI CAN lines on bench
Ok do you mean check can resister in ECU caus I used 2nd hand BSI and have same problem

metercar
30th June, 2014, 12:59 PM
CAN resistor is a passive, verify on bench the CAN lines with oscilloscope and power up ECU and BSI out of wiring car, remember the IN-OUT CAN lines in ABS system if this is equipped.

metercar
30th June, 2014, 01:17 PM
266298
power up and check if talk it's ok