Fec001
1st July, 2014, 06:24 PM
Hello!
Can you give me a step by step instructions for put this ECU boot mode with galetto?
I wired ECU, give 12V adapter to galetto solder 1000ohm resistor to boot pin. Choose the SAK-TC1796 Boot mode.
When I click connect after galetto only asks me to remove and give feeding to ECU before continue. Nothing about when connect the boot wire to bootpin like older ECUs like MM ST10xx or Siemens infineon C167
Can you give me a step by step instructions for put this ECU boot mode with galetto?
I wired ECU, give 12V adapter to galetto solder 1000ohm resistor to boot pin. Choose the SAK-TC1796 Boot mode.
When I click connect after galetto only asks me to remove and give feeding to ECU before continue. Nothing about when connect the boot wire to bootpin like older ECUs like MM ST10xx or Siemens infineon C167