VAG EDC17CP14 boot mode with galetto 2

[Fec001]

Hello!
Can you give me a step by step instructions for put this ECU boot mode with galetto?
I wired ECU, give 12V adapter to galetto solder 1000ohm resistor to boot pin. Choose the SAK-TC1796 Boot mode.
When I click connect after galetto only asks me to remove and give feeding to ECU before continue. Nothing about when connect the boot wire to bootpin like older ECUs like MM ST10xx or Siemens infineon C167

[morgano]

Just follow image and on screen instructions.

http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=266503&d=1404238297

Click connect on fgtech sw as you did, then power on the ecu with the bootpin connected and hit OK on the dialog.

Just that.

[Fec001]

I did that and after some time it asks the same again " Remove and give feeding to ECU before continue"
The resistor is only 980ohm, is that could be problem?

EDIT:

Solved. In my PDF CAN Low is seems yellow. I saw on yours, it is orange.

[morgano]

Yellow is L-Line ;)

[spec jarek]

704933
I have the same problem, can anyone help what should be put down?