Fiat Ducato EDC15C7 ECU pinout.

[Fec001]

Hello!
I want to read this ECU on table in boot mode. Can someone give me the pinouts for supply V and k-line please?

[bersch8688]

Test this Pinout ;-)

267117

[Fec001]

This is old EDC15 not C7. Anyway I found it on google. Thank you!

[Fec001]

Used this pinout but can't communicate with ECU on table. Measured supply voltage all ok.....hm, interesting. When I put ECU back to car I can communicate, galetto2 can red ECU ID but can't read flash, "changing speed error". I'm afraid I must desolder flash :(

[morgano]

Desolder eeprom and try again on bench to read flash. ;)

Or use bootmode.

[Fec001]

On bench ECU was completely silent. (it didn't consume any V/A) I tried to plug back on car's harness and set to boot mode but nothing. Only ID can't read flash. Next time I'll try with desoldered eprom. Now it's done by flash desoldering :/.
If anyone can recommend something what can read these EDC15C7 ECUs without boot, that would great.

[morgano]

Immo prevents operation, if you desolder eeprom it should be possible r/w on bench without need of bootmode.

But bootmode if well done bypass immo check.

Regards,

[Fec001]

Thanks! I'll try that

[sntfrancisco]

Hello
I read and flash my Ducato 2.3 JTD By OBD 1260, and all OK.

[Fec001]

Desolder eeprom and try again on bench to read flash. ;)

Or use bootmode.

that's work!!!!! thanks