PDA

View Full Version : help needed for good tuning on my peugeot 1.4hdi 206 from 2009 its a 0 281 012 526ecu



el_futte
5th July, 2014, 04:05 PM
here is a full BDM read out of the flash

its a 68hp ?ko racer

betrescudan
5th July, 2014, 05:08 PM
try these and report

el_futte
5th July, 2014, 05:42 PM
thats was not a good one., came whit ecu fault at the same,. and care starts but run op and down in rpm i go a little hard in engine .. mate

betrescudan
5th July, 2014, 06:14 PM
but when you readed the ecu it was stored some fault?

el_futte
5th July, 2014, 06:16 PM
railpressur sensor fault

el_futte
5th July, 2014, 06:24 PM
my bad ,, it have finger in the bad edu.. i try whit new edu it says 528 at the last bosch number.,. there you tuning works .. can you many get the turbo start a earlier ??? its came about 2000rpm now.. its a new turbo on it .. car have run 120333km ,, so could be nice to fell the power a little more

betrescudan
5th July, 2014, 06:26 PM
try these one and report...but if you readed the ecu with some fault memmorised,can be the only problemmm....please retry,i modiffied the rail pressure

betrescudan
5th July, 2014, 06:28 PM
retry for peugeot

betrescudan
5th July, 2014, 06:30 PM
turbo start at 1500rpm...is good...

betrescudan
5th July, 2014, 06:32 PM
try these first other modiffications

betrescudan
5th July, 2014, 06:46 PM
i.m waiting your report please...

betrescudan
5th July, 2014, 06:54 PM
hi morgano...was up?

NOX
5th July, 2014, 07:34 PM
the turbo has not pierburg!

betrescudan
5th July, 2014, 07:38 PM
what is that pierburg ?

NOX
5th July, 2014, 07:59 PM
the turbo has not pierburg
ECU does not monitor turbocharged
edc16c34 control turbocharged 1600 hdi
maps are missing important on the injection

betrescudan
5th July, 2014, 08:01 PM
please take a look of my map and make it good...and post for annalyze please

betrescudan
5th July, 2014, 08:07 PM
please take a look of my map and make it good...and post for annalyze please

NOX
5th July, 2014, 08:30 PM
is not managed by ecu
managed 1600 hdi vgt
1400 hdi fixed geometry

betrescudan
5th July, 2014, 08:43 PM
ok...but you can work the turbo pressure and boost...no need in this case vgt...map is ok

NOX
5th July, 2014, 09:02 PM
You can not lift pressure from map

betrescudan
5th July, 2014, 09:15 PM
thanks...i see...but isn,t any probblem to use this map...power is comming from injection in this case,and turbo help in normally parrameters