ford psg5 virginise problem

[gccb]

please i need to make psg5 fuel pump module virgin, i m using bosch kts to do the job but adaptation stops at 880s and i got loss of communication with ecu as message.
any help?
regards.

[vasko]

you can reset with kts .....
remove psg electronic and connect direct

[gccb]

you mean remove control unit frompump?

[vasko]

yes
2 variant
you need plug from pump electronic and obd connector
Contact them directly...
without remove

[gccb]

my problem is not here i can connect topsg and read fault memory but when i start adaption it stops at 880s left and says no communication with cintrol unit.

[vasko]

hey friend i can send picture
after 20min

[vasko]

pump connector 6 > 4,5obd ground
pump connector 7 > 16obd +12v
pump connector 1 > 14 can
pump connector 2 > 6 can
pump connector 9 >7 obd k line
insert pin pump connector 9 and connect to 7 obd
Use the battery to power supply
sucsess

[gccb]

my problem is not there i can communicate with psg but adaptation process stops at 880s

[vasko]

try this method 100% working

[i_shot_the_sheriff]

After virgin pump light is not blinking ! But i get error B2139 which means programming between PCM and Fuel Pump ! Can KTS make that program? It needs Incode Outcode ?

[gttrd]

Hi

Did you get the solution to this issue
Im after encountering it this evening

Thanks

Darren

[i_shot_the_sheriff]

I programmed the car with focom function for immo and car started mate

Sent from my SM-G930F using Tapatalk