edc15 maf smoke map

[yeager]

hi, can anyone help me how can i find this map in ecm titanium or in winols? one man show me before how turn off MAF sensor but it was a years before and never ust it, and now i dont know where begin :-(
can anyone help me?

[bobolin4o]

What car, which ECU...? Better post your file here...
Regards!

[yeager]

here is, i know that exist 2 methods, which is better?

[yeager]

realy noone :(

[betrescudan]

wait bobolin40...now is not on-line...i"m sure that help you...and is good to do that

[waldi1979]

Do you mean 6CBD2 13X16 ???

[yeager]

When it is maf smoke map then ... yes :-)

[monitel_service]

yes this is Smoke Limit

[bobolin4o]

I think, in your case, must change 2 switches (8 bit, 71AF0 and 71AF1) from 0 to 1... and calibrate the map at addres 6D270.
If you want to remove completely the MAF sensor, you should to remove all MAF related DTCs in the dump...
May be i'm wrong, let more knowledgeable than me, confirm that...
Regards!

[dean 21]

Hi, must put MAF smoke limiter all map to zero "0" at adress 6cbd2, and use switch like bobolin4o says to change MAF to MAP limiter map work, than must edit MAP limiter map at adress 6d270.
But, MAP limiter map at the ori file is limited at 50mg IQ like you see, must configured to real iq, witch is not easy.
Engine always work better with maf limiter map, or both, to calculate how much fuel to add must know how many air become in engine.

[yeager]

where you fing this map???

[bobolin4o]

where you fing this map???

In the dump of course. Start address of map is 6D270 - 13x16.
Use Winols!

[yeager]

hm interest, one man show me all different method ... he open one map in ecu2001 (dont remember which one it was) and rewrite all value to maximum from this map ... i think to 4700 and MAF was turned off ... car dont go to limp mode ... second method was, that change maf smoke map to 1000-2000-3000-4000 and it was too ok ...

[bobolin4o]

This is not MAFless modification, this is just "no smoke limiter via MAF sensor" If in your dump MAP based smoke limiter is calibrated - will work by this way, but it isn't... so you must calibrate this map at address, that is given above...

[Diagnosticated]

where you fing this map???

if you want to learn. Start here: https://www.youtube.com/playlist?list=PLxYpxtRjTQYJie-xnCH_Unx4l65Cu6W-r