Audi A3 2.0 TDI - DPF problem after remove DPF - help needed

[jasiek77]

hello all


I have Audi A3 2.0 TDI 140 PS - 2006
EDC16c34 - 03G906021AB


I have a problem with the correct except DPF. When I cut him off by switch car starts correctly but does not enter a higher speed than 3000 rpm.
When I turned off the mistakes of the DTC car enters above 3000 rpm but terribly smokes black smoke. I've tried many ways but to no avail ... I do not really know where my problem lies.


I hope that someone far more experienced could help me...


GREETINGS

272586

[Diagnosticated]

what address did you change in the file?

[jasiek77]

1D4204

Original byte 01 change to 00

DTC i try disabled in EcuSafe

[ecupro]

Here your file with dpf off, it should work.
272602

[icezero2010]

1D4204

Original byte 01 change to 00

DTC i try disabled in EcuSafe

wrong adress 1D4274 is correct

[jasiek77]

My mistake i change exactly 1D4274... After that car not enter a higher speed than 3000 rpm.

Maybe DTC I changed wrong...

[Diagnosticated]

My mistake i change exactly 1D4274... After that car not enter a higher speed than 3000 rpm.

Maybe DTC I changed wrong...
You should not change dtc. not needed if switch is correct. Did you reset dpf to new before changing file.

[icezero2010]

My mistake i change exactly 1D4274... After that car not enter a higher speed than 3000 rpm.

Maybe DTC I changed wrong...

any error in ecu ???

software incompatible?

[ominimicu]

switch solution requires all sensors conected and working!

[icezero2010]

switch solution requires all sensors conected and working!

no some software versions have this problem ! most 3.0tdi and 2.7 tdi !

[jasiek77]

I change MAF sensor and car have power and no smoke but error P0401 EGR... What can I do with this error?

[icezero2010]

I change MAF sensor and car have power and no smoke but error P0401 EGR... What can I do with this error?
189e74 20x1 set to zero HILO 16Bit

189f6a 20x1 set to zero HILO 16Bit