SKODA SUPERB DPF

[steveeprom]

I need DPF off skoda superb year 2008-9 ecu EDC16.
SW: 1037395411
Engine: R4 2,0L EDC
SW upg.: 03G906021QP

Have try anyone the volta? work on this ecu?

[cawadany]

For this ECU there is the dpf switch off

[steveeprom]

with Volta work?

[cawadany]

Volta erases DTC area

[cawadany]

Dpf off by switch off. For you. Pass in PM

Reset dpf values before writing file.

[steveeprom]

Thanks you I will try

[steveeprom]

I test the file but the car has black smoke BEFORE AND after dpf off

[cawadany]

Do you have reset the dpf values ​​and made ​​the substitution of dpf by diagnostic tool?

[steveeprom]

Yes before dpf file i do with vcds (replace the dpf)
I test the file but the car has black smoke BEFORE AND after dpf off

[cawadany]

The dpf is physically removed?

[bobolin4o]

But "DPF off" does not mean there will be no black smoke!
"DPF off" mean - no regeneration, no limp mode with errors related to too much soot content e.t.c.
If this car have black smoke behind, check for bad turbo, or air leak between turbo and air inlet of the engine.
And finally, stop do this "DPF off" all the time... the problem isn't there always!
Regards!

[steveeprom]

I agree with you but ,I am not do DPF of all the time, I do only when is necessary ,to do like you said. "DPF off" mean - no regeneration, no limp mode with errors related to too much soot content e.t.c. Thanks

[olmar]

I need DPF off and remove DTC P1958 skoda superb year 2008-9 ecu EDC16.
SW: 1037395411
Engine: R4 2,0L EDC
SW upg.: 03G906021QP 2893

[drewdom]

Here file for You cs done:

[olmar]

Here file for You cs done:

Hello , I had just tested the dump file and P1958 is missing smile2 the problem is that error P0546 and P2002 appeared on diag . can you remove this one too , please ? thank you in advance

[chipdanix]

Hello , I had just tested the dump file and P1958 is missing smile2 the problem is that error P0546 and P2002 appeared on diag . can you remove this one too , please ? thank you in advance





disconnect the three sensors and will be fine

exhaust gas temperature , dpf ,temperature exhaust gas catalyst

[SRestaca]

Tengo el mismo problema de humo negro a bajas rpm poca fuerza a bajas revoluciones desde 2400rpm bien