View Full Version : Soot mass reset in eeprom VAG EDC16
tomlib
2nd September, 2014, 06:45 PM
Hi, I must reset soot mass in VW Touareg 3.0TDI edc16cp34. I didn't see in vcds any adaptation (channel 12 is not available) or basic setting. I have no way to force regeneration because I got the car without physically dpf:( I'm reading ecu bdm. Ecusafe solution to reset soot mass in eeprom don't work.
Could you help me reset this in eeprom?
Thanks in advance!
ludbe
2nd September, 2014, 08:28 PM
what if you set with autocom-new dpf filter installed?
kospoz
2nd September, 2014, 09:01 PM
i agree with ludbe mate i use autocom for this
tomlib
3rd September, 2014, 09:03 AM
Thanks friends for reply but BKS engine code in Autocom 2013.3 don't have optione new filter. Only regeneration...
kazikk
3rd September, 2014, 09:12 AM
try this one.
tomlib
3rd September, 2014, 09:52 AM
this is ecusafe solution but not work, glow plug lamp blinking and limp mode
digi men
3rd September, 2014, 10:53 AM
If you have dpf removed physically from car, you need dpf off in flash file, than you need to do whit a diagnostic toll adapt new dpf than write new flash whit dpf off to the car.
oem
3rd September, 2014, 12:52 PM
Channel 50 and 51 in basic setting to reset DPF
b2s15
3rd September, 2014, 08:28 PM
autocom also for me to reset dpf
pablo1971
3rd September, 2014, 11:22 PM
this is a easy dpf off...re write ecu with dpf off file...reset dpf settings with good diag tool...autocom-top tool...
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.