Bmw E36 EWS

[antlio]

Hi

I have a car Bmw E36 318IS model 1996 and yesterday morning car didn t crank . After a while and many effords car started at once and when i swiched off the ignition and tried again didn t crank . I remove the Ews II with yellow connector
61.35-8 362 277 and mcu 68HC11E9 security and i read . Can someone take a look at this file and repair it to start the car ?

regards

[vlado kljucar]

WBABE71020ES36313 3 key is used, I think your file is good,did you connect car on diagnostic? And did you put key on device to see is it transponder ok?

[bram380]

Here fixed dump:

[antlio]

Hi
To VLADO I connect tester and there isn t fault in the ecu but in ews immo fault .
To BRAM I will try and i will tell you . If i will write your file to ews the car will start ok or it will needs inpa to synchro ?

regards

[bram380]

Hi
To VLADO I connect tester and there isn t fault in the ecu but in ews immo fault .
To BRAM I will try and i will tell you . If i will write your file to ews the car will start ok or it will needs inpa to synchro ?

regards

Car will start, if ews from same car.

[antlio]

Ews is from the car .

[antlio]

Hi

Thanks Bram . Car had problem with EWS . When i write your repair file in EWS car didn t crank . After when i changed the EWS with used with same numbers and your repair file car cranked and started .

regards