View Full Version : Need original Flash files for VW Passat
naelraddad
13th September, 2014, 06:26 PM
hi friends I need original flash files for any one the following passat ecu's please I need your help urgent
06B 906 033 AD
06B 906 033 AP
06B 906 033 AN
06B 906 033 AC
06B 906 033 T
06B 906 033 M
06B 906 033 N
06B 906 033 J
I will be thankful for your help
naelraddad
16th September, 2014, 07:56 PM
friends I need you help these files are very important for me
regards
veloseeped
16th September, 2014, 09:16 PM
I see you ask for MT versions of ecu.
Do you want to change ecu after AT то MT swap?
If I'm right, give ecu number you have now on former AT car, because not all ecu from list above are compatible for dump change.
naelraddad
17th September, 2014, 07:07 AM
I see you ask for MT versions of ecu.
Do you want to change ecu after AT то MT swap?
If I'm right, give ecu number you have now on former AT car, because not all ecu from list above are compatible for dump change.
thank you friend for your reply
you are right friend the car was changed from AT to Manual transmission the original ecu on the car is
06B 906 033 AA
this ecu does not accept manual transmission coding
Big thanks
veloseeped
17th September, 2014, 10:31 AM
06B 906 033 AA
Your file is 033T.
This is ori raw dump for programing desoldered flash in external programmer.
If you use boot mode in-circuit program you must convert this file with Simos3 algo.
After reprogram change coding from xxxx3 to xxxx1
naelraddad
17th September, 2014, 11:07 AM
Your file is 033T.
This is ori raw dump for programing desoldered flash in external programmer.
If you use boot mode in-circuit program you must convert this file with Simos3 algo.
After reprogram change coding from xxxx3 to xxxx1
thank you friend for your help I did not have external programmer I use FGtech version 53 for programing I did not know how to convert this file with Simos3 algo so may you help me to convert the file
Big thanks
veloseeped
17th September, 2014, 03:17 PM
I use FGtech version 53 for programing I did not know how to convert this file with Simos3
Ups... this may be a problem.
Over OBD connector you read/write dump PARTIALLY not full.
To make new ecu functional you must change full dump.
It's possible if you will write flash in boot mode on the bench.
Anyway make read 033AA with your tool and post here - will see what file format-coding you need.
naelraddad
20th September, 2014, 11:04 AM
Ups... this may be a problem.
Over OBD connector you read/write dump PARTIALLY not full.
To make new ecu functional you must change full dump.
It's possible if you will write flash in boot mode on the bench.
Anyway make read 033AA with your tool and post here - will see what file format-coding you need.
Thank you friend for your help one of my friends told me that me has Chinese MiniPro programmer which can program the flash chip on bench I will try it and report you what happened
big Regards
Powered by vBulletin® Version 4.2.5 Copyright © 2024 vBulletin Solutions Inc. All rights reserved.