PDA

View Full Version : Passat 2.0 TDI Siemens PPD map info



Fec001
14th September, 2014, 04:51 PM
Hello!
Someone give me infos about map at 735C8 16x16?????

chriskross
14th September, 2014, 05:41 PM
when you have this sw versi in BDM read i can give you all adresses

morgano
14th September, 2014, 06:05 PM
Seems Limp mode torque limiter.

Fec001
14th September, 2014, 06:45 PM
when you have this sw versi in BDM read i can give you all adresses

I have BDM file too and have all map addresses but doesn't understand that map.
Anyway, mappack says that is "TL for monitoring error"

Fec001
14th September, 2014, 08:09 PM
Another map that I don't know is 51C52 16x16. Anyone knows what could it be?

chriskross
14th September, 2014, 08:26 PM
do you have damos?

Fec001
14th September, 2014, 10:08 PM
No I haven't

Fec001
15th September, 2014, 08:30 PM
no one can help me?

smayer
16th September, 2014, 01:17 AM
maybe this can help PPD Maps | jazdw.net (http://jazdw.net/ppd-maps)

Fec001
16th September, 2014, 07:11 AM
Tried but didin't helped at these maps.

Fec001
17th September, 2014, 10:27 PM
Can someone confirm that, there is no smoke or lamdba limiter in this soft?

Fec001
19th September, 2014, 10:36 PM
Smoke limiters at 652F0 and 654F0 16x16???? Can someone help me with axis?

morgano
19th September, 2014, 11:16 PM
Maybe remove offser from Y axis and it can be MAF

Fec001
20th September, 2014, 01:09 PM
Axes now 1, 2, 3....... etc because in PPD axes located elsewhere from the map. So there is no offset. As I know smoke limiter map axes should be RPM and MAP in Siemens PPD.

morgano
20th September, 2014, 02:15 PM
0x652f0 -> X 0x452cc , Y 0x44f68

It share axis with 0x654f0.

And you a right it is MAP value one o the axis.


Regards,

Fec001
20th September, 2014, 04:37 PM
all clear now thank you! First mod made without touching smoke limiter, car is very good. Now I try with increasing it at lower MAP and RPM a bit.

mornie
29th September, 2014, 01:25 PM
install ppd maps there are lots examples it will tell you also where the axes starts !!! if you look the maps then you see the address of the axis :-)

Fec001
30th September, 2014, 12:16 PM
But not at this ECU soft version. Smoke limiter was missing.