Audi A4 03G906018AQ DPF

[autocentarvu]

Hi!

I have here A4 170 PS 03G906018AQ Siemens PPD 1.3 with DPF problem. Car was in limp mode and lights where on on dash (MIL and yellow heater) and on FIS also.
First I was try to read it with MPPS and do it with Volta but MPPS did not want to write file back and I have DEAD car.
OF COURSE MMPS DO NOT READ GOOD BACKUP and I stuck with non runner.
Than I find BDM file from same car like mine and write it trough BDM and now I have good starter/runner.
Now there is no any MIL lamps on dash exept on FIS
Can someone help me here to disable this DPF totaly please but not with Volta or Ecuscan ( I don't want to do same procedure after 100-2000 miles)?

Thanks in advance

Best regards

P.S. If you have car like mine do not try to write any file with MPPS or you are gonna ended with dead car!!!



277727

[smt]

why dont use fgtech for read /write obd?

[autocentarvu]

After I ended with dead car I decided to use BDM. With MPPS when try to flash "Ecu don't respond".
Fgtech will probably work but I didn't want to experiment any more.

[ecupro]

I can confrim this too, few days ago I read VW Passat 2006 2.0 TDI Siemens ppd1.5 with MPPS, when I try to write moded file back it gave error on 1%, then I try to write original file back and car start again normally.

[autocentarvu]

You have luck. I can not even write original backup back.

[xanubysx]

Write this file via BDM and after test start...277872

[xanubysx]

MPPS and FGTECH write PPD goods....

[kukukatsu]

MPPS works like a charm with siemens pdd!! Volta also :joyous: