PDA

View Full Version : 2013 GM XC2361 READING


AMLGAR
30th September, 2014, 02:20 AM
has anybody try to read GM MODULES 2012 UP XC2361 WITH ETL? i tried but no success programmer is not detecting +12v supply, i did it as shows the picture in software.. any advice would be appreciate...I KNOW THIS MODULE CAN RESET BY OBDII IN THE CAR , but i just want to test my programmer, ALSO IF SOMEONE KNOW HOW TO CONNECT WITH SCANTOOL IN THE TABLE would be appreciate thanks...
repairmymodule
30th September, 2014, 12:28 PM
For on-bench scanning be sure to connect 120-500 ohm resistance between CAN + and CAN - lines.

What model is it for? I will post pinout for CAN lines and POWER lines when i get to the shop.
luis12
30th September, 2014, 03:48 PM
Did you conected unit with 12V and ground external source?.
AMLGAR
30th September, 2014, 04:36 PM
For on-bench scanning be sure to connect 120-500 ohm resistance between CAN + and CAN - lines.

What model is it for? I will post pinout for CAN lines and POWER lines when i get to the shop.

2013 buick verano
repairmymodule
30th September, 2014, 06:15 PM
OK, looks like the airbag module isnt on the CAN network, its on GM Low Speed Serial line, so connect 12V and Ground to scanner and SRS ecu. Then run a wire from pin 2 of the scanner to pin 15 of the air bag module. (Note: only one wire is required for data communication, WITHOUT termination (no resistance))


Good Luck



Sorry the image is hard to read.


24-Pin Connector
---------------------------
Pin 9 - BATTERY Hot
Pin 15 - Serial Data Line
Pin 17 - Ignition Switched
Pin 19 - GROUND
datapage
1st October, 2014, 12:26 PM
use full all cruze


279758
AMLGAR
2nd October, 2014, 06:10 PM
OK, looks like the airbag module isnt on the CAN network, its on GM Low Speed Serial line, so connect 12V and Ground to scanner and SRS ecu. Then run a wire from pin 2 of the scanner to pin 15 of the air bag module. (Note: only one wire is required for data communication, WITHOUT termination (no resistance))


Good Luck





Sorry the image is hard to read.


24-Pin Connector
---------------------------
Pin 9 - BATTERY Hot
Pin 15 - Serial Data Line
Pin 17 - Ignition Switched
Pin 19 - GROUND

no luck to read like this ON TABLE, i think has a gateway with BCM, ETL picture is missed another +12v, now it read flash...