PDA

View Full Version : GOLF 5 1.4 FSI DON?T START AFTER PROGRAMING



BrunoPT
8th October, 2014, 01:08 AM
Hello everyone
I need a your help.


I have here a golf 5 1.4 fsi for 90hp
I opened the unit and read by bdm (flash_read file)
I made an off dtc calculated the checksum and recorded in the unit, it happens that the car will not start or light up the engine light on the dashboard. I try to put the file read and yet also not handle. What repair is that when writing for bdm initially wrote in + \ - 5m and now everything I write is written in 2m.


Someone can give me a hint?

ECU: BOSCH MED 9.5.10
SOFTWARE: 1037376084
HARDWARE: 0261S02004


Attached file originally read (flash)
eeprom
File with DTC P1035 off


Thank you

Fantomisback
8th October, 2014, 01:23 AM
Hello everyone
I need a your help.


I have here a golf 5 1.4 fsi for 90hp
I opened the unit and read by bdm (flash_read file)
I made an off dtc calculated the checksum and recorded in the unit, it happens that the car will not start or light up the engine light on the dashboard. I try to put the file read and yet also not handle. What repair is that when writing for bdm initially wrote in + \ - 5m and now everything I write is written in 2m.


Someone can give me a hint?

ECU: BOSCH MED 9.5.10
SOFTWARE: 1037376084
HARDWARE: 0261S02004


Attached file originally read (flash)
eeprom
File with DTC P1035 off


Thank you

Hi i think your checksum is not ok u can try this file

BrunoPT
8th October, 2014, 01:30 AM
i will try, but for example, read by bdm initially to make the car work and does not do

BrunoPT
8th October, 2014, 10:10 AM
Don?t work.

TCSTigersClaw
8th October, 2014, 11:30 AM
Maybe you damaged the ECU while trying to open it.......

ominimicu
8th October, 2014, 12:11 PM
MEd 9 get damaged v easy . as they are v v hard to open especially if u want to reach the other side where the bosch BDM pads are.
PS: it has normal bdm pads on the first side!

Fec001
8th October, 2014, 01:04 PM
or make chk with BDM100

BrunoPT
8th October, 2014, 02:19 PM
Opening the unit was made ​​as I usually do and never had problems.
I will soon have a new test file.
I hope I have not corrupt is the micro