corsa D

[ruffles1986]

Hi mates. I have in garage a Opel Corsa D from '08 1.3jtd Z13DTJ. The car not start after repair crash. I not have comunication with abs, power steering and ecu. I test the ecu in bench and have comunication. The BCM trough some faults some present and some not present...about twenty faults, i try to erase it but without sucessefully. Then i thinking can be BCM faulty. Any had similar problem with this BCM?? Any way to reset BCM ?or if it is blocked is not possible unlock? Can this BCM locked short comunication with ECU and ABS?? I wait for yours suggestions. Regards and thanks

[racin-snake]

If you have tech2 do a module presence check and come back with results

[aidyk]

disconnect airbag module ! see what happens please. !

[ruffles1986]

If you have tech2 do a module presence check and come back with results

I not have Tech2, i have abrites commander and op-com.

[ruffles1986]

disconnect airbag module ! see what happens please. !
The car came from other garage where they said the car start without problem, but when they move the car to other place one time, try to start and not start anymore...

[radiosolutions]

Bcm goes corrupt m8. Done a few. Program keys and info back in. If does not work you will have to replace bcm

[ruffles1986]

Bcm goes corrupt m8. Done a few. Program keys and info back in. If does not work you will have to replace bcm
writing eeprom from other bcm and ressting can solve the problem? is normal that BCM faulty short comunication with modules connected to Can High? (ECU,ABS and powr steering)

[super jumbe]

Airbag module and instrument cluster need to be synchronise with ECU the only known solution….

[ruffles1986]

Then if i has not comunication with these modules there is not solution or the problem came from other place

[chrisys123]

Please post the eeprom from your ECU. Maybe I can help you. I've had the same problem with Fiat Punto EVO 1.3 JTD

[Ashraf6119]

Hi

You said you have Op-Com than why don't you diagnose and post your fault code.........

Try Auto Scan option if you see Auto Scan option fails than you know that your BCM has lost its configuration with other ECU............

Than diagnose individual ECU and post your fault codes here...........

[chrisys123]

Your error is "Wrong Environment Identifier"?

[ruffles1986]

Hi

You said you have Op-Com than why don't you diagnose and post your fault code.........

Try Auto Scan option if you see Auto Scan option fails than you know that your BCM has lost its configuration with other ECU............

Than diagnose individual ECU and post your fault codes here...........


I have Op-com and abrites commander. Abrites 281886281887281888281889281890can comunicate with BCM but op-com not. i see that op-com try comunicate with bcm in hs-can, and abrites open channel in LS-CAN. i can't erase this DTC's present or not present.