PDA

View Full Version : Dahiatsu Terios 2008 Add key data to immo file please



llaverosv
21st October, 2014, 06:56 PM
hi, need please to add this key data for this immo from a Daihatsu Terios 2008, immo 89780-b4020, eeprom 93c66. all key lost.

key data from ID 67
PG1. B2

PG2. 35

PG3. C9 BD 3A 16

DATA STREAM PAG4. 7E 3A BD C9 51 36 C8 12 80 0B

manasrah
21st October, 2014, 09:12 PM
u can add key manual but u must to make ffffff in immo box then turn swetch on 5 time //////////

llaverosv
21st October, 2014, 11:47 PM
hi, thanks for answer. FFFFF in all the immo file ?. and then just cycle keys ?, need to do 30 minutes bridge on obd2 ? thanks for your help
mauricio

fadhle
22nd October, 2014, 08:53 AM
You must use 4D ID 67 with pg1 52 .
To add new key:
-connect 13 +4 with jumber.
-insert the working key and Ig on, when you note the security flash.
-Switch Ig off then remove working key.
-Insert new key then Ig on, after you note security off.
-switch Ig off, remove jumber and start your car.

iamfooser
22nd October, 2014, 03:21 PM
Use the attached file.

Once immo box plugged in, the LED will be solid.
Insert key with pg1 52, if key is recognise it will blink once and then stay solid.
Register 2nd key if you want to, if not cycle key 5 times to close registration.

llaverosv
22nd October, 2014, 03:50 PM
nice !!!! i?m on my way will let you know

gwee
22nd October, 2014, 03:58 PM
nice !!!! i?m on my way will let you know

make sure you have the right key

iamfooser
22nd October, 2014, 04:16 PM
<br />
id 67 key 1 master<br />
P1: 52<br />
P2: 4E<br />
P3: C3 98 0B 04<br />
P4: A7 0D B0 E6 8B<br />
<br />
id 67 key 2<br />
P1: 52<br />
P2: 2E<br />
P3: DF 26 BD 16<br />
P4: 3B 5D FC B3 3B<br />

In the event you need the right key data. :)

Bllinda
22nd October, 2014, 07:14 PM
How to_record_key again scan_damp.

irwin88
25th October, 2014, 06:06 AM
Bllinda, u can use iamfooser posted reset file, write the file. Plug in the immo box, immo light will immediately turn ON. Prepare 2 pcs of Daihatsu keys, insert key 1 into ignition, immo light will turn OFF and ON back again. Pull out key 1, insert 2nd key, immo light will be OFF by then. Test the key to start car.
Note: if you intend to program 1 key only. Insert key and after that turn ignition ON x OFF 5 times. Once immo light goes OFF, you can start the car.

llaverosv
25th October, 2014, 04:08 PM
thanks again for your support !!!!