Ford DCP-806 ST10F269 pin out

[tomlib]

Hi, does someone have any experience with a galletto and a Ford Transit 2.0TDDI from 2005 with ST10F269? I have tried to read the ecu by obd2, but it does not work.

Someone have pinout to xprog or galletto in boot mode?

http://www.digital-kaos.co.uk/forums/attachment.php?attachmentid=284538&stc=1

Thanks in advance

[betrescudan]

only byteshooter with the special cable ST10F276 can do this my friend

[tomlib]

I saw this photo friend, but if this processor supports xprog in the worst case is the direct connection of the st10.

I saw also a picture of soldered cables to "service" connectors and other 2 wire and he was reading by xprog.Unfortunately picture was not readable enough to connect the same.