help with porsche boxster airbag 99761821707

[motocarlos]

Hello all,

i have a problem with a porsche boxster from 2008 i have change the baterie, and when i turn key on to start the car, the airbag ligth stay on and on the computer board too.

I try to delete the dtc, but 1 error stay, on the delphi diagnostic tool, says upside airbag error.

I have mesured all the pinout on the unit and all is ok, so maybee its the airbag unit with problems or the file??


can anyone help me to clear the file??

boxster 2008 99761821707 with eprom 95320

best regards.

[motocarlos]

Anyone have some original file for this ecu, even with crash??

99761821707

regards.

[amir_82013]

Please tell me Exactly DTC code ( with PIWIS or GT1 or Launch diag or AVDI or ... )

[motocarlos]

Please tell me Exactly DTC code ( with PIWIS or GT1 or Launch diag or AVDI or ... )


dtc are: 8023 with delphi diagnostic airbag driver side up, short to ground

and with Berton diagnostic is B0023 unknow error.

[kolocar]

I'm not suer but check it,,,,clear by hexeditor.your dump maybe have 3 DTCs with org files,did you deleted DTC before read 95320?

[motocarlos]

I'm not suer but check it,,,,clear by hexeditor.your dump maybe have 3 DTCs with org files,did you deleted DTC before read 95320?

hello,

i will try and report back.

Thanks and regards.

[amir_82013]

i check dump and DTC , not found info crash
i think no problem srs unit
DTC 8023: airbag driver side up, (short to ground)
Disconnected battery and check connections this module

you see with Diag parameters resistor modules

[motocarlos]

i check dump and DTC , not found info crash
i think no problem srs unit
DTC 8023: airbag driver side up, (short to ground)
Disconnected battery and check connections this module

you see with Diag parameters resistor modules

hello,

the file not good, always keep same error,
i have check all resistor airbag in the plug airbag ecu and all good, maybee is the ecu really bad??

I will check again all the aibag conections and report back.

Regards.

[amir_82013]

please see with Diagnostic Device parameters resistor all modules