Smok PSA in BSI

[Repinator]

Please help me with working procedure PSAinBSI for example today I will have a 2011 C4 Picasso and do not know how to
First correct km BSI with dash mounted or removed dash and after that correct BSI???
Maybe send me some documentation or how to do it
Thank you

[javyb]

Do bsi by obd then select c4 dash read info then write km

[javyb]

Keep dash connected and finally erase errors

[moto111]

I am looking to buy Smok PSA in BSI tool pm dealer please

[automocion]

Is this tool working good for obd bsi to older cars like: 2001-2006 xsara picasso, 2005 C4, 307 bsi?

[Repinator]

I am looking to buy Smok PSA in BSI tool pm dealer please

SMOK (http://www.smok.com.pl/index.php?lang=en&id=oferta&kategoria=1&produkt=53)

[Repinator]

Keep dash connected and finally erase errors

I'll try tomorrow
thank you

[moto111]

could someone please tell me the procedure for citreon berlingo with psa tool ( do i do dash on the bench and program bsi with dash out of vehicle with same value ?? ) any help appreciated

[Apolo29]

What model? year?

[moto111]

What model? year?

Sorry its Peugeot Partner Van year 2011

[carbandit]

could someone please tell me the procedure for citreon berlingo with psa tool ( do i do dash on the bench and program bsi with dash out of vehicle with same value ?? ) any help appreciated

disconnect dash and do manually ...then do bsi by obd2 wait until its done then put dash back in

[moto111]

disconnect dash and do manually ...then do bsi by obd2 wait until its done then put dash back in

Cheers Mate..............

[moto111]

Ok i hope some PSA Tool users would lend me there time and explain a few things as i got no instructions from smok, the BSI is a johnston control and the psa tool says cannot read eeprom with this BSI so i type in the required kms and away it does its thing, after about 50mins writing it suggests i save a file ( I dont know if this is a flash file or what as i didnt read and save anything before this ) so i saved it then it says do you want to reflash it yes/no so i pressed yes so after a couple of attempts it has written and when i check the mileage when i plugged in the dashboard nothing has changed, ( and yes i did have the dashboard out while programming and did change the dash on the bench, could someone point out where i went wrong, please

[fruti]

Ok mate, one tip .... When tool says "cannot read eeprom with this BSI" Stop procedure ... It may cause damage and you end up with more problems.
I guess tool didn't do anny damage.
Pull BSI out and read and change it manualy ... Or ... call Grezgorz SMOK over phone tomorrow and he will tell you what to do!

Regards