PDA

View Full Version : mini remote stopped working



ninja123
1st December, 2014, 08:27 AM
my friend has a 2008 mini with only 1 dash key, but remote just stop working.

I checked signal and frequency and all ok.

Is there a re sync procedure for this type of key or will it need to have a new key programmed?

Thanks for any advice, ninja

keyprogramming
1st December, 2014, 09:39 AM
Don't be misled by frequency testing.
Been caught out a few times, with what appeared to be an OK remote, that turned out to be faulty, usually a weak signal.

obdsystems
1st December, 2014, 10:30 AM
check receiver unit cos if like other CAS BMWs the receiver unit (combined with radio)
gets water ingress n packs up.

But that's a guess. diagnostics may report fault.

Like to know the outcome mate

ninja123
1st December, 2014, 06:40 PM
typical dumb customer, fault was not remote, it was working perfect, but car not starting :)

Key was faulty, unable to read transponder, so made a pcf7936 with avdi, put it in side casing and we have another runner :)

ninja