iamfooser
1st December, 2014, 04:32 PM
How can I adapt this new cluster? I would like to upgrade from old NEC+24C62 to NEC+24C62 TFT (2013-).
I read data from old cluster and I write the data like CS, pin, Mac, and vin to new cluster. Then I program key to new cluster.
I could see the data when I read the immo data again but car could not start. It started for 3 secs and then die. I have fault code of P1570 - MIL ON
Any advise on what I should do? What are the normal procedure to change a new cluster?
I notice that the cluster have PRO word in it. Does it mean cluster is new?
Please advise.
regards
I read data from old cluster and I write the data like CS, pin, Mac, and vin to new cluster. Then I program key to new cluster.
I could see the data when I read the immo data again but car could not start. It started for 3 secs and then die. I have fault code of P1570 - MIL ON
Any advise on what I should do? What are the normal procedure to change a new cluster?
I notice that the cluster have PRO word in it. Does it mean cluster is new?
Please advise.
regards