Audi A6 MM4 3K91D

[iamfooser]

Tried to add key for this car with VVDI, manage to read pin and CS but couldnt add key with it.

Take my MVP out to program the key and manage to gain access with the pin (8857) but it did not learn the keys. Keys from 3 to 0.

Tried to do eeprom job with tango, but not recognised.

Attached is the dump after keys are 0.


By vvdi,
Pin: 08857
CS: 11 31 3B 58 7C 99 BC

Am I missing something here?

[easternghost]

pin seems to be correct

[yugo45]

This is Immo 3 , use diagnostic and program key.

[iamfooser]

I think the problem is with the coil or car. I will have a look at the car again. [emoji106]

[topclef]

here your dump edited , if you've tango you can use it , now it recognised

Good luck

[iamfooser]

here your dump edited , if you've tango you can use it , now it recognised

Good luck
I will try and report soon. Thanks.

[iamfooser]

I think something is wrong with the cluster now. The information on the dash is not available.

I can't communicate with the cluster also. Will check the flash and eeprom tmr.

Sigh

[iamfooser]

Flash was corrupted. Program a good flash and cluster is working like normal again. But car did not start.

No signal from coil. Changed a new coil and it is still the same. Finally did immo off for the car. Thanks for the help!