Mileage w203 question

[sasy90]

Hi, i've question for dp3 (elprosys) users... It can do w203 (eis+dash) via obd?

[VirtualTech]

yes you can, but if you wont perfect job you must change km via obd and take aut ezs form car and change km programmer because new km who you write via obd it's big, more very big as much as 1 million

[esse]

yes you can, but if you wont perfect job you must change km via obd and take aut ezs form car and change km programmer because new km who you write via obd it's big, more very big as much as 1 million

And how make you
not EZS w203 by obd in my dp3 4.94
thanks

[sasy90]

yes o no??

[VirtualTech]

if in ezs mcu 9s12 work by obd if in ezs 908 you don't do by obd. What year this car?

[sasy90]

has 908...car is 2001...ok thanks

[VirtualTech]

yes this is 908, very dangerous read this mcu. For carfly job you must desolder mcu and read etl programmer .

[MarkPRP]

Flash the dash, remove link between dash and eZs of software is correct In dash..

[sasy90]

Flash the dash, remove link between dash and eZs of software is correct In dash..

can you explain this procedure?i never do it...

[bersch8688]

This EZS done with R270

Work perfect

[MarkPRP]

Or r270 for EZS.

Look in dp3 options,

[TULGEYWOODMAN]

This is the most confusing thread I have ever read

[MarkPRP]

Confusing because someone with a dp3 doesn't know how to do mileage on an w203?

[TULGEYWOODMAN]

Confusing because someone with a dp3 doesn't know how to do mileage on an w203?

Confusing because 6,743 dk members refer to Digiprog as dp3.........diagprog was always referred to as dp3, suddenly Digiprog gets cloned and it's called dp3 also..........aghhhhhh! No wonder threads like this emerge, confusion reigns.

[sasy90]

thanks to all my friend...i've done this car with my enigma...i would know only if dp3 (ORIGINAL) can do by obd because i want buy it for my workshop christmas......thanks...i want also dp3 for complete this works....

[kelekele]

Good for you.
In some cases you must have soldering skils if somethig goes wrong with ezs.

[twincam]

can you explain this procedure?i never do it...
You can do this dash using dash plug st60 conector with Digi , it will do the dash and syncro with ezs will be turned off .