406 remote programming

[purdy]

Repaired a 406 remote new switch and pad Transmitting lovely . Struggling to resync / program to car. Tried all manual methods. Can't find remote programming in pp2000. Any ideas? Not sure why they have primary and secondary remotes.

2button RF remote
Purdy

Sent from my iPad using Tapatalk HD

[ninja123]

should just be the normal procedure mate, ign on and hold lock button for 10 seconds.

ninja

[rapidlocksmiths]

theres 2 different procedures for 406

the first is below for 406 and 605 models ;

1. Turn the Ignition switch ON.
2. Press the large Plip key button (Primary Plip)
3. Within 10 seconds, press the large Plip key button (Secondary Plip)
4. If there is one remote, press the Primary plip button twice.
5. Turn ignition OFF.
6. Test Plip’s for correct operation.


NB : On some 406 models, Plips cannot be re-synchronised unless the battery has been disconnected for 1 minute , " IF DOING A RESET REMEMBER TO FOLLOW CORRECT PROCEDURE FOR DISCONNECTING BATTERY OR YOU WILL CORRUPT THE BSI " 5 minute rule !

the second is below for 406 2001 > ( D9) ;

1. Press and hold large button and then press and hold the small button for 20 seconds.
2. Release both buttons, the indicator light on the plip will illuminate.
3. Press the large button once and the light will go out.
4. Switch the ignition ‘ON’ for 3 to 5 seconds.
5. Switch the ignition ‘OFF’ and remove the key.
6. Lock and Unlock the vehicle with the remote to test

good luck

[purdy]

Have not seen that second procedure will give it a go tomorrow.



Sent from my iPad using Tapatalk HD

[purdy]

Worked a treat . Some one had removed the central locking fuse. So could not see that it had programmed in. Many thanks


Purdy

[obdsystems]

And (some) customers think its a 5 minute job. Hope you got paid for your effort purdy