PDA

View Full Version : S2000-1 PIN


zeljolaki
15th December, 2014, 01:29 PM
Hi!
Does anyone programmable PIN A4C5 in this damp?
Ecu Sagem S2000-1,eeprom 95080 !
tqnata83
15th December, 2014, 03:34 PM
org PIN is M1CT

file belov pin is changed to A4C5
you must change and VIN
Zmann
15th December, 2014, 04:13 PM
Actual PIN on this ECU is read swap byte, so incorrect.

Anyway just simply insert the PIN car will not start!
zeljolaki
15th December, 2014, 04:28 PM
Actual PIN on this ECU is read swap byte, so incorrect.

Anyway just simply insert the PIN car will not start!
yes,car dont start :-( ,pls repair my dump, my bsi PIN is A4C5
ruwi
15th December, 2014, 06:23 PM
Just do immo off on this ecu. Very simple...
Bllinda
15th December, 2014, 07:36 PM
VIN....44299 BSI pin A4C5 is different.

yes,car dont start :-( ,pls repair my dump, my bsi PIN is A4C5
zeljolaki
15th December, 2014, 09:14 PM
Just do immo off on this ecu. Very simple...
Yes,I did immo off, the car is started, but board computer throws error "engine imobiliser fault", the client's mind, insisting that the fix... :-(
Zmann
16th December, 2014, 01:43 AM
Three different PIN's are here, which car part is from original? BSI Sagem gray case? key original to which PIN?

If with more detail there are more chances that you can get help. Don't waste your time putting just PIN in either BSI or ECU.
zeljolaki
16th December, 2014, 01:12 PM
Three different PIN's are here, which car part is from original? BSI Sagem gray case? key original to which PIN?

If with more detail there are more chances that you can get help. Don't waste your time putting just PIN in either BSI or ECU.

Ecu is a genuine, old BSI is broken (MCU can not be read), I put the BSI and the key with donor car, with Lexia i configured chassis number, and other functions of the BSI, Everything is working normally, it is necessary to synchronize the BSI and ECU .. Currently I have made immo off, the car is running but the trip computer prints the error "engine immobilizer fault", the client needs to fix ...
BSI damp which I have attached a from donor BSI, before I set VIN and other functions..

Thanks for help!!
Zmann
17th December, 2014, 12:13 PM
Two possibilities aside from immo off, both needs Lexia.

'Part replacement> ECU', proceed similary to as you did 'I put the BSI and the key with donor car', this case donor PIN is used. The ECU needs virgin dump. You can go with this option if having the dump BUT I've found none of working one. or

'Part replacement> BSI', keep the ECU all original of cause original PIN is used. Can use only original key or telecoding failed. Will need a virgin BSI dump or try with said FFFFFFF